1 files changed, 64 insertions, 34 deletions

diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index 5278ffb20e74..950b97d7412a 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -529,6 +529,18 @@ void mmc_set_data_timeout(struct mmc_data *data, const struct mmc_card *card)
 			data->timeout_clks = 0;
 		}
 	}
+
+	/*
+	 * Some cards require longer data read timeout than indicated in CSD.
+	 * Address this by setting the read timeout to a "reasonably high"
+	 * value. For the cards tested, 300ms has proven enough. If necessary,
+	 * this value can be increased if other problematic cards require this.
+	 */
+	if (mmc_card_long_read_time(card) && data->flags & MMC_DATA_READ) {
+		data->timeout_ns = 300000000;
+		data->timeout_clks = 0;
+	}
+
 	/*
 	 * Some cards need very high timeouts if driven in SPI mode.
 	 * The worst observed timeout was 900ms after writing a
@@ -1213,6 +1225,46 @@ void mmc_set_driver_type(struct mmc_host *host, unsigned int drv_type)
 	mmc_host_clk_release(host);
 }
 
+static void mmc_poweroff_notify(struct mmc_host *host)
+{
+	struct mmc_card *card;
+	unsigned int timeout;
+	unsigned int notify_type = EXT_CSD_NO_POWER_NOTIFICATION;
+	int err = 0;
+
+	card = host->card;
+
+	/*
+	 * Send power notify command only if card
+	 * is mmc and notify state is powered ON
+	 */
+	if (card && mmc_card_mmc(card) &&
+	    (card->poweroff_notify_state == MMC_POWERED_ON)) {
+
+		if (host->power_notify_type == MMC_HOST_PW_NOTIFY_SHORT) {
+			notify_type = EXT_CSD_POWER_OFF_SHORT;
+			timeout = card->ext_csd.generic_cmd6_time;
+			card->poweroff_notify_state = MMC_POWEROFF_SHORT;
+		} else {
+			notify_type = EXT_CSD_POWER_OFF_LONG;
+			timeout = card->ext_csd.power_off_longtime;
+			card->poweroff_notify_state = MMC_POWEROFF_LONG;
+		}
+
+		err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
+				 EXT_CSD_POWER_OFF_NOTIFICATION,
+				 notify_type, timeout);
+
+		if (err && err != -EBADMSG)
+			pr_err("Device failed to respond within %d poweroff "
+			       "time. Forcefully powering down the device\n",
+			       timeout);
+
+		/* Set the card state to no notification after the poweroff */
+		card->poweroff_notify_state = MMC_NO_POWER_NOTIFICATION;
+	}
+}
+
 /*
  * Apply power to the MMC stack.  This is a two-stage process.
  * First, we enable power to the card without the clock running.
@@ -1269,42 +1321,12 @@ static void mmc_power_up(struct mmc_host *host)
 
 void mmc_power_off(struct mmc_host *host)
 {
-	struct mmc_card *card;
-	unsigned int notify_type;
-	unsigned int timeout;
-	int err;
-
 	mmc_host_clk_hold(host);
 
-	card = host->card;
 	host->ios.clock = 0;
 	host->ios.vdd = 0;
 
-	if (card && mmc_card_mmc(card) &&
-	    (card->poweroff_notify_state == MMC_POWERED_ON)) {
-
-		if (host->power_notify_type == MMC_HOST_PW_NOTIFY_SHORT) {
-			notify_type = EXT_CSD_POWER_OFF_SHORT;
-			timeout = card->ext_csd.generic_cmd6_time;
-			card->poweroff_notify_state = MMC_POWEROFF_SHORT;
-		} else {
-			notify_type = EXT_CSD_POWER_OFF_LONG;
-			timeout = card->ext_csd.power_off_longtime;
-			card->poweroff_notify_state = MMC_POWEROFF_LONG;
-		}
-
-		err = mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
-				 EXT_CSD_POWER_OFF_NOTIFICATION,
-				 notify_type, timeout);
-
-		if (err && err != -EBADMSG)
-			pr_err("Device failed to respond within %d poweroff "
-			       "time. Forcefully powering down the device\n",
-			       timeout);
-
-		/* Set the card state to no notification after the poweroff */
-		card->poweroff_notify_state = MMC_NO_POWER_NOTIFICATION;
-	}
+	mmc_poweroff_notify(host);
 
 	/*
 	 * Reset ocr mask to be the highest possible voltage supported for
@@ -2196,7 +2218,7 @@ int mmc_card_sleep(struct mmc_host *host)
 
 	mmc_bus_get(host);
 
-	if (host->bus_ops && !host->bus_dead && host->bus_ops->awake)
+	if (host->bus_ops && !host->bus_dead && host->bus_ops->sleep)
 		err = host->bus_ops->sleep(host);
 
 	mmc_bus_put(host);
@@ -2302,8 +2324,17 @@ int mmc_suspend_host(struct mmc_host *host)
 		 * pre-claim the host.
 		 */
 		if (mmc_try_claim_host(host)) {
-			if (host->bus_ops->suspend)
+			if (host->bus_ops->suspend) {
+				/*
+				 * For eMMC 4.5 device send notify command
+				 * before sleep, because in sleep state eMMC 4.5
+				 * devices respond to only RESET and AWAKE cmd
+				 */
+				mmc_poweroff_notify(host);
 				err = host->bus_ops->suspend(host);
+			}
+			mmc_do_release_host(host);
+
 			if (err == -ENOSYS || !host->bus_ops->resume) {
 				/*
 				 * We simply "remove" the card in this case.
@@ -2318,7 +2349,6 @@ int mmc_suspend_host(struct mmc_host *host)
 				host->pm_flags = 0;
 				err = 0;
 			}
-			mmc_do_release_host(host);
 		} else {
 			err = -EBUSY;
 		}