1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
|
/***************************************************************************
* __________ __ ___.
* Open \______ \ ____ ____ | | _\_ |__ _______ ___
* Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ /
* Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < <
* Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \
* \/ \/ \/ \/ \/
* $Id$
*
* Copyright (C) 2002 by Heikki Hannikainen, Uwe Freese
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version 2
* of the License, or (at your option) any later version.
*
* This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY
* KIND, either express or implied.
*
****************************************************************************/
#ifndef _POWERMGMT_H_
#define _POWERMGMT_H_
#include <stdbool.h>
#define POWER_HISTORY_LEN 2*60 /* 2 hours of samples, one per minute */
enum charge_state_type
{
/* sorted by increasing charging current (do not change!) */
#if CONFIG_CHARGING >= CHARGING_MONITOR
CHARGE_STATE_DISABLED = -2, /* Disable charger use (safety measure) */
CHARGE_STATE_ERROR = -1, /* Some error occurred that should not allow
turning on the charger again by software
without user intervention (ie. replug) */
#endif
DISCHARGING = 0,
#if CONFIG_CHARGING >= CHARGING_MONITOR
TRICKLE, /* For NiCd, battery maintenence phase */
/* For LiIon, low-current precharge phase */
TOPOFF, /* For NiCd, waiting for dead zone */
/* For LiIon, constant voltage phase */
CHARGING, /* For NiCd, main charge phase */
/* For LiIon, constant current phase */
#endif
};
/* tells what the charger is doing */
extern enum charge_state_type charge_state;
#ifdef CONFIG_CHARGING
/*
* Flag that the charger has been plugged in/removed: this is set for exactly
* one time through the power loop when the charger has been plugged in.
*/
enum charger_input_state_type
{
NO_CHARGER = 0, /* No charger is present */
CHARGER_UNPLUGGED, /* Transitional state during CHARGER=>NO_CHARGER */
CHARGER_PLUGGED, /* Transitional state during NO_CHARGER=>CHARGER */
CHARGER /* Charger is present */
};
/* tells the state of the charge input */
extern enum charger_input_state_type charger_input_state;
/* Power input status saved on the power thread each loop */
extern unsigned int power_thread_inputs;
#endif /* CONFIG_CHARGING */
#if CONFIG_CHARGING == CHARGING_TARGET
/* Include target-specific definitions */
#include "powermgmt-target.h"
#endif
#ifndef SIMULATOR
/* Generic current values that are intentionally meaningless - config header
* should define proper numbers.*/
#ifndef CURRENT_BACKLIGHT
#define CURRENT_BACKLIGHT 5 /* additional current when backlight always on */
#endif
#if defined(HAVE_RECORDING) && !defined(CURRENT_RECORD)
#define CURRENT_RECORD 2 /* additional recording current */
#endif /* HAVE_RECORDING && !CURRENT_RECORD*/
#ifndef CURRENT_USB
#define CURRENT_USB 2 /* usual current in mA in USB mode */
#endif
#if defined(HAVE_REMOTE_LCD) && !defined(CURRENT_REMOTE)
#define CURRENT_REMOTE 2 /* additional current when remote connected */
#endif /* CURRENT_REMOTE && !HAVE_REMOTE_LCD */
#if CONFIG_CHARGING
#ifndef CURRENT_MAX_CHG
#define CURRENT_MAX_CHG 350 /* maximum charging current */
#endif
#endif /* CONFIG_CHARGING */
#ifdef CHARGING_DEBUG_FILE
#define POWERMGMT_DEBUG_STACK ((0x1000)/sizeof(long))
#else
#define POWERMGMT_DEBUG_STACK 0
#endif
#ifndef BATT_AVE_SAMPLES
/* slw filter constant unless otherwise specified */
#define BATT_AVE_SAMPLES 128
#endif
#ifndef POWER_THREAD_STEP_TICKS
/* 2HZ sample rate unless otherwise specified */
#define POWER_THREAD_STEP_TICKS (HZ/2)
#endif
extern unsigned short power_history[POWER_HISTORY_LEN];
extern const unsigned short battery_level_dangerous[BATTERY_TYPES_COUNT];
extern const unsigned short battery_level_shutoff[BATTERY_TYPES_COUNT];
extern const unsigned short percent_to_volt_discharge[BATTERY_TYPES_COUNT][11];
#if CONFIG_CHARGING
extern const unsigned short percent_to_volt_charge[11];
#endif
/* Start up power management thread */
void powermgmt_init(void) INIT_ATTR;
#endif /* SIMULATOR */
/* Returns battery statust */
int battery_level(void); /* percent */
int battery_time(void); /* minutes */
unsigned int battery_adc_voltage(void); /* voltage from ADC in millivolts */
unsigned int battery_voltage(void); /* filtered batt. voltage in millivolts */
#ifdef HAVE_BATTERY_SWITCH
unsigned int input_millivolts(void); /* voltage that device is running from */
#endif /* HAVE_BATTERY_SWITCH */
#if defined(HAVE_BATTERY_SWITCH) || defined(HAVE_RESET_BATTERY_FILTER)
/* Set the filtered battery voltage (to adjust it before beginning a charge
* cycle for instance where old, loaded readings will likely be invalid).
* Also readjust when battery switch is opened or closed.
*/
void reset_battery_filter(int millivolts);
#endif /* HAVE_BATTERY_SWITCH || HAVE_RESET_BATTERY_FILTER */
/* read unfiltered battery info */
void battery_read_info(int *voltage, int *level);
/* Tells if the battery level is safe for disk writes */
bool battery_level_safe(void);
void set_poweroff_timeout(int timeout);
void set_battery_capacity(int capacity); /* set local battery capacity value */
int get_battery_capacity(void); /* get local battery capacity value */
void set_battery_type(int type); /* set local battery type */
void set_sleep_timer(int seconds);
int get_sleep_timer(void);
void set_car_adapter_mode(bool setting);
void reset_poweroff_timer(void);
void cancel_shutdown(void);
void shutdown_hw(void);
void sys_poweroff(void);
/* Returns true if the system should force shutdown for some reason -
* eg. low battery */
bool query_force_shutdown(void);
#ifdef HAVE_ACCESSORY_SUPPLY
void accessory_supply_set(bool);
#endif
#endif /* _POWERMGMT_H_ */
|
