summaryrefslogtreecommitdiff
path: root/firmware/target/arm/usb-target.h
AgeCommit message (Collapse)Author
2011-12-31usb-target.h: removeRafaël Carré
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31498 a1c6a512-1295-4272-9138-f99709370657
2011-12-31USBOTG_ARC's USB_DRIVER_CLOSE: move to config.hRafaël Carré
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31494 a1c6a512-1295-4272-9138-f99709370657
2011-12-31firewire/usb_remove/insert_int: move to system-target.hRafaël Carré
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31491 a1c6a512-1295-4272-9138-f99709370657
2011-12-31usb_plugged() is PP onlyRafaël Carré
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31489 a1c6a512-1295-4272-9138-f99709370657
2011-12-31move usb_pin_init() declaration to PP's system-target.hRafaël Carré
remove duplicate usb_detect() declaration Remove all content from empty usb-target.h files git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31488 a1c6a512-1295-4272-9138-f99709370657
2011-12-31usb_init_device(): move prototype to usb.hRafaël Carré
Get rid of some usb-target.h files git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31487 a1c6a512-1295-4272-9138-f99709370657
2011-01-15Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time ↵Michael Sevakis
being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly). git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29053 a1c6a512-1295-4272-9138-f99709370657
2009-01-22Use bus reset detection for all ARC OTG devices. Remove conflict from ↵Michael Sevakis
LV24020LP driver with some GPIO-by-number macros for PP502x. Start monitoring for USB stack once all core threads and queues are created otherwise queues will likely be registered after USB acks. Putting PP502x system_reboot in IRAM (unmapped, uncached) memory seems to help it work more consistently. Hopefully I got all the PP USB connect handlers in the right spot in irq_handler. If device seems unresponsive to cable, check there first. git-svn-id: svn://svn.rockbox.org/rockbox/trunk@19819 a1c6a512-1295-4272-9138-f99709370657
2009-01-19USB detection changes. c200/e200: Consider USB to be powered when charger is ↵Michael Sevakis
plugged but detect USB connection by bus reset. When received, disconnect and restart the driver fully enabled. imx31: Fix hack used to make initial connect succeeded-- set PHY type before initial reset. General: Move some target code out of usb-drv-arc.c and implement it in respective usb sources and CPU headers so things stay clean. git-svn-id: svn://svn.rockbox.org/rockbox/trunk@19797 a1c6a512-1295-4272-9138-f99709370657
2008-06-28Updated our source code header to explicitly mention that we are GPL v2 orDaniel Stenberg
later. We still need to hunt down snippets used that are not. 1324 modified files... http://www.rockbox.org/mail/archive/rockbox-dev-archive-2008-06/0060.shtml git-svn-id: svn://svn.rockbox.org/rockbox/trunk@17847 a1c6a512-1295-4272-9138-f99709370657
2007-02-04Fix USB detection on ipods and other portalplayer targets - Rockbox now ↵Dave Chapman
correctly distinguishes between a USB connection to a computer and a connection to a USB AC charger. Based on the experimental USB code in FS #6494 by Barry Wardell. Closes FS #4724. git-svn-id: svn://svn.rockbox.org/rockbox/trunk@12198 a1c6a512-1295-4272-9138-f99709370657
2006-12-20Combine USB code for all PortalPlayer targets since they most likely all use ↵Barry Wardell
the same USB hardware. Add register defines for the USB hardware addresses, based off the Freescale i.MX31 datasheet. Use usb_init() from the iPod code, but modified to use the new register defines rather than oul/inl on the hardware addresses. git-svn-id: svn://svn.rockbox.org/rockbox/trunk@11823 a1c6a512-1295-4272-9138-f99709370657
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-05 13:37:45 +0000