blob: 4fe14deedc0a3e5aa3988288873c5e4f9a2ee01c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
|
LEDs connected to GPIO lines
Required properties:
- compatible : should be "gpio-leds".
Each LED is represented as a sub-node of the gpio-leds device. Each
node's name represents the name of the corresponding LED.
LED sub-node properties:
- gpios : Should specify the LED's GPIO, see "Specifying GPIO information
for devices" in Documentation/powerpc/booting-without-of.txt. Active
low LEDs should be indicated using flags in the GPIO specifier.
- label : (optional) The label for this LED. If omitted, the label is
taken from the node name (excluding the unit address).
- linux,default-trigger : (optional) This parameter, if present, is a
string defining the trigger assigned to the LED. Current triggers are:
"backlight" - LED will act as a back-light, controlled by the framebuffer
system
"default-on" - LED will turn on
"heartbeat" - LED "double" flashes at a load average based rate
"ide-disk" - LED indicates disk activity
"timer" - LED flashes at a fixed, configurable rate
Examples:
leds {
compatible = "gpio-leds";
hdd {
label = "IDE Activity";
gpios = <&mcu_pio 0 1>; /* Active low */
linux,default-trigger = "ide-disk";
};
};
run-control {
compatible = "gpio-leds";
red {
gpios = <&mpc8572 6 0>;
};
green {
gpios = <&mpc8572 7 0>;
};
}
|
