blob: 1aad0514e6474be4171e854ae5265d872cc7c89c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
|
Freescale vf610 Analog to Digital Converter bindings
The devicetree bindings are for the new ADC driver written for
vf610/i.MX6slx and upward SoCs from Freescale.
Required properties:
- compatible: Should contain "fsl,vf610-adc"
- reg: Offset and length of the register set for the device
- interrupts: Should contain the interrupt for the device
- clocks: The clock is needed by the ADC controller, ADC clock source is ipg clock.
- clock-names: Must contain "adc", matching entry in the clocks property.
- vref-supply: The regulator supply ADC reference voltage.
Recommended properties:
- fsl,adck-max-frequency: Maximum frequencies according to datasheets operating
requirements. Three values are required, depending on conversion mode:
- Frequency in normal mode (ADLPC=0, ADHSC=0)
- Frequency in high-speed mode (ADLPC=0, ADHSC=1)
- Frequency in low-power mode (ADLPC=1, ADHSC=0)
- min-sample-time: Minimum sampling time in nanoseconds. This value has
to be chosen according to the conversion mode and the connected analog
source resistance (R_as) and capacitance (C_as). Refer the datasheet's
operating requirements. A safe default across a wide range of R_as and
C_as as well as conversion modes is 1000ns.
Example:
adc0: adc@4003b000 {
compatible = "fsl,vf610-adc";
reg = <0x4003b000 0x1000>;
interrupts = <0 53 0x04>;
clocks = <&clks VF610_CLK_ADC0>;
clock-names = "adc";
fsl,adck-max-frequency = <30000000>, <40000000>,
<20000000>;
vref-supply = <®_vcc_3v3_mcu>;
};
|
