blob: 528f5ef5a8932edcd05b0ccf5ad40971d410ca9a (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
|
ImgTec TZ1090 PDC GPIO Controller
Required properties:
- compatible: Compatible property value should be "img,tz1090-pdc-gpio".
- reg: Physical base address of the controller and length of memory mapped
region. This starts at and cover the SOC_GPIO_CONTROL registers.
- gpio-controller: Specifies that the node is a gpio controller.
- #gpio-cells: Should be 2. The syntax of the gpio specifier used by client
nodes should have the following values.
<[phandle of the gpio controller node]
[PDC gpio number]
[gpio flags]>
Values for gpio specifier:
- GPIO number: a value in the range 0 to 6.
- GPIO flags: bit field of flags, as defined in <dt-bindings/gpio/gpio.h>.
Only the following flags are supported:
GPIO_ACTIVE_HIGH
GPIO_ACTIVE_LOW
Optional properties:
- gpio-ranges: Mapping to pin controller pins (as described in
Documentation/devicetree/bindings/gpio/gpio.txt)
- interrupts: Individual syswake interrupts (other GPIOs cannot interrupt)
Example:
pdc_gpios: gpio-controller@2006500 {
gpio-controller;
#gpio-cells = <2>;
compatible = "img,tz1090-pdc-gpio";
reg = <0x02006500 0x100>;
interrupt-parent = <&pdc>;
interrupts = <8 IRQ_TYPE_NONE>, /* Syswake 0 */
<9 IRQ_TYPE_NONE>, /* Syswake 1 */
<10 IRQ_TYPE_NONE>; /* Syswake 2 */
gpio-ranges = <&pdc_pinctrl 0 0 7>;
};
|
