summaryrefslogtreecommitdiff
path: root/drivers
AgeCommit message (Expand)Author
2011-04-25ath9k_htc: Fix AMPDU subframe handlingSujith Manoharan
2011-04-25ath9k: Fix warnings from -Wunused-but-set-variableSujith Manoharan
2011-04-25ssb: cc: use correct min_msk for 0x4312Rafał Miłecki
2011-04-25ssb: pci: trivial: correct amount of maximum retriesRafał Miłecki
2011-04-25ath9k_hw: Enable AR9340 supportVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Disable INTR_HOST1_FATAL to avoid interrupt strom with ar9430Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Assign macversion based on devid for built-in wmacVasanthakumar Thiagarajan
2011-04-25ath9k: Add AR9340 platform id to id tableVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Read iq calibration data only for active chainsVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Configure chain switch table and attenuation control only for activ...Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Enable byte Tx/Rx data swap for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Configure tuning capacitance value for AR9340 as wellVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Skip internal regulator configuration for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Don't configure AR_CH0_THERM for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Fix register offset AR_PHY_65NM_CH0_THERM for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Clean up rx/tx chain configuration before AGC/IQ calVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Configure RF channel freqency for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Read spur frequency information from eeprom for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Initialize tx and rx gain table from initvals.h for ar9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Don't do ani initialization for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Initialize mode registers from initvals.h for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Add initvals.h for ar9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Configure pll control register accordingly for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Get AHB clock information from ath9k_platform_dataVasanthakumar Thiagarajan
2011-04-25ath9k_hw: Take care of few host interface register changes for AR9340Vasanthakumar Thiagarajan
2011-04-25ath9k_hw: Define devid and mac version for AR9340Vasanthakumar Thiagarajan
2011-04-25Merge branch 'wireless-next-2.6' of git://git.kernel.org/pub/scm/linux/kernel...John W. Linville
2011-04-25Merge branch 'for-linville' of git://git.kernel.org/pub/scm/linux/kernel/git/...John W. Linville
2011-04-22iwlagn: remove hw_ready variableJohannes Berg
2011-04-22iwlagn: combine firmware code/dataJohannes Berg
2011-04-22iwlagn: implement synchronous firmware loadJohannes Berg
2011-04-22iwlagn: leave notification waits on firmware errorsJohannes Berg
2011-04-22iwlagn: make iwlagn_wait_notification return error codeJohannes Berg
2011-04-22iwlagn: extend notification wait functionJohannes Berg
2011-04-22iwlagn: refactor up pathJohannes Berg
2011-04-22iwlagn: refactor down pathJohannes Berg
2011-04-22iwlagn: clean up some exit codeJohannes Berg
2011-04-22iwlagn: simplify error table readingJohannes Berg
2011-04-19rt2x00: Implement get_antenna and set_antenna callback functionsIvo van Doorn
2011-04-19rt2x00: Implement get_ringparam callback functionIvo van Doorn
2011-04-19rt2x00: Optimize register access in rt2800usbIvo van Doorn
2011-04-19rt2x00: Optimize register access in rt2800pciHelmut Schaa
2011-04-19rt2x00: Merge rt2x00ht.c contents in other files.Gertjan van Wingerde
2011-04-19rt2x00: Enable support for RT53xx PCI devices by default.Gertjan van Wingerde
2011-04-19rt2x00: RT33xx device support is no longer experimental.Gertjan van Wingerde
2011-04-19rt2x00: Add USB IDs.Gertjan van Wingerde
2011-04-19rt2x00: Allow dynamic addition of PCI/USB IDs.Gertjan van Wingerde
2011-04-19rt2x00: Linksys WUSB600N rev2 is a RT3572 device.Gertjan van Wingerde
2011-04-19rt2x00: Always inline rt2x00pci_enable_interruptHelmut Schaa
2011-04-19rt2x00: Decrease association time for USB devicesIvo van Doorn