diff options
Diffstat (limited to 'drivers/gpu/drm/i915/i915_reg.h')
| -rw-r--r-- | drivers/gpu/drm/i915/i915_reg.h | 152 |
1 files changed, 150 insertions, 2 deletions
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h index f3e39cc46f0d..cf41c672defe 100644 --- a/drivers/gpu/drm/i915/i915_reg.h +++ b/drivers/gpu/drm/i915/i915_reg.h @@ -178,6 +178,7 @@ #define MI_OVERLAY_OFF (0x2<<21) #define MI_LOAD_SCAN_LINES_INCL MI_INSTR(0x12, 0) #define MI_DISPLAY_FLIP MI_INSTR(0x14, 2) +#define MI_DISPLAY_FLIP_I915 MI_INSTR(0x14, 1) #define MI_DISPLAY_FLIP_PLANE(n) ((n) << 20) #define MI_STORE_DWORD_IMM MI_INSTR(0x20, 1) #define MI_MEM_VIRTUAL (1 << 22) /* 965+ only */ @@ -334,6 +335,7 @@ #define I915_DEBUG_INTERRUPT (1<<2) #define I915_USER_INTERRUPT (1<<1) #define I915_ASLE_INTERRUPT (1<<0) +#define I915_BSD_USER_INTERRUPT (1<<25) #define EIR 0x020b0 #define EMR 0x020b4 #define ESR 0x020b8 @@ -357,6 +359,70 @@ #define LM_BURST_LENGTH 0x00000700 #define LM_FIFO_WATERMARK 0x0000001F #define MI_ARB_STATE 0x020e4 /* 915+ only */ +#define MI_ARB_MASK_SHIFT 16 /* shift for enable bits */ + +/* Make render/texture TLB fetches lower priorty than associated data + * fetches. This is not turned on by default + */ +#define MI_ARB_RENDER_TLB_LOW_PRIORITY (1 << 15) + +/* Isoch request wait on GTT enable (Display A/B/C streams). + * Make isoch requests stall on the TLB update. May cause + * display underruns (test mode only) + */ +#define MI_ARB_ISOCH_WAIT_GTT (1 << 14) + +/* Block grant count for isoch requests when block count is + * set to a finite value. + */ +#define MI_ARB_BLOCK_GRANT_MASK (3 << 12) +#define MI_ARB_BLOCK_GRANT_8 (0 << 12) /* for 3 display planes */ +#define MI_ARB_BLOCK_GRANT_4 (1 << 12) /* for 2 display planes */ +#define MI_ARB_BLOCK_GRANT_2 (2 << 12) /* for 1 display plane */ +#define MI_ARB_BLOCK_GRANT_0 (3 << 12) /* don't use */ + +/* Enable render writes to complete in C2/C3/C4 power states. + * If this isn't enabled, render writes are prevented in low + * power states. That seems bad to me. + */ +#define MI_ARB_C3_LP_WRITE_ENABLE (1 << 11) + +/* This acknowledges an async flip immediately instead + * of waiting for 2TLB fetches. + */ +#define MI_ARB_ASYNC_FLIP_ACK_IMMEDIATE (1 << 10) + +/* Enables non-sequential data reads through arbiter + */ +#define MI_ARB_DUAL_DATA_PHASE_DISABLE (1 << 9) + +/* Disable FSB snooping of cacheable write cycles from binner/render + * command stream + */ +#define MI_ARB_CACHE_SNOOP_DISABLE (1 << 8) + +/* Arbiter time slice for non-isoch streams */ +#define MI_ARB_TIME_SLICE_MASK (7 << 5) +#define MI_ARB_TIME_SLICE_1 (0 << 5) +#define MI_ARB_TIME_SLICE_2 (1 << 5) +#define MI_ARB_TIME_SLICE_4 (2 << 5) +#define MI_ARB_TIME_SLICE_6 (3 << 5) +#define MI_ARB_TIME_SLICE_8 (4 << 5) +#define MI_ARB_TIME_SLICE_10 (5 << 5) +#define MI_ARB_TIME_SLICE_14 (6 << 5) +#define MI_ARB_TIME_SLICE_16 (7 << 5) + +/* Low priority grace period page size */ +#define MI_ARB_LOW_PRIORITY_GRACE_4KB (0 << 4) /* default */ +#define MI_ARB_LOW_PRIORITY_GRACE_8KB (1 << 4) + +/* Disable display A/B trickle feed */ +#define MI_ARB_DISPLAY_TRICKLE_FEED_DISABLE (1 << 2) + +/* Set display plane priority */ +#define MI_ARB_DISPLAY_PRIORITY_A_B (0 << 0) /* display A > display B */ +#define MI_ARB_DISPLAY_PRIORITY_B_A (1 << 0) /* display B > display A */ + #define CACHE_MODE_0 0x02120 /* 915+ only */ #define CM0_MASK_SHIFT 16 #define CM0_IZ_OPT_DISABLE (1<<6) @@ -367,7 +433,40 @@ #define CM0_RC_OP_FLUSH_DISABLE (1<<0) #define BB_ADDR 0x02140 /* 8 bytes */ #define GFX_FLSH_CNTL 0x02170 /* 915+ only */ +#define ECOSKPD 0x021d0 +#define ECO_GATING_CX_ONLY (1<<3) +#define ECO_FLIP_DONE (1<<0) + +/* GEN6 interrupt control */ +#define GEN6_RENDER_HWSTAM 0x2098 +#define GEN6_RENDER_IMR 0x20a8 +#define GEN6_RENDER_CONTEXT_SWITCH_INTERRUPT (1 << 8) +#define GEN6_RENDER_PPGTT_PAGE_FAULT (1 << 7) +#define GEN6_RENDER TIMEOUT_COUNTER_EXPIRED (1 << 6) +#define GEN6_RENDER_L3_PARITY_ERROR (1 << 5) +#define GEN6_RENDER_PIPE_CONTROL_NOTIFY_INTERRUPT (1 << 4) +#define GEN6_RENDER_COMMAND_PARSER_MASTER_ERROR (1 << 3) +#define GEN6_RENDER_SYNC_STATUS (1 << 2) +#define GEN6_RENDER_DEBUG_INTERRUPT (1 << 1) +#define GEN6_RENDER_USER_INTERRUPT (1 << 0) + +#define GEN6_BLITTER_HWSTAM 0x22098 +#define GEN6_BLITTER_IMR 0x220a8 +#define GEN6_BLITTER_MI_FLUSH_DW_NOTIFY_INTERRUPT (1 << 26) +#define GEN6_BLITTER_COMMAND_PARSER_MASTER_ERROR (1 << 25) +#define GEN6_BLITTER_SYNC_STATUS (1 << 24) +#define GEN6_BLITTER_USER_INTERRUPT (1 << 22) +/* + * BSD (bit stream decoder instruction and interrupt control register defines + * (G4X and Ironlake only) + */ +#define BSD_RING_TAIL 0x04030 +#define BSD_RING_HEAD 0x04034 +#define BSD_RING_START 0x04038 +#define BSD_RING_CTL 0x0403c +#define BSD_RING_ACTHD 0x04074 +#define BSD_HWS_PGA 0x04080 /* * Framebuffer compression (915+ only) @@ -805,6 +904,10 @@ #define DCC_CHANNEL_XOR_DISABLE (1 << 10) #define DCC_CHANNEL_XOR_BIT_17 (1 << 9) +/** Pineview MCH register contains DDR3 setting */ +#define CSHRDDR3CTL 0x101a8 +#define CSHRDDR3CTL_DDR3 (1 << 2) + /** 965 MCH register controlling DRAM channel configuration */ #define C0DRB3 0x10206 #define C1DRB3 0x10606 @@ -826,6 +929,12 @@ #define CLKCFG_MEM_800 (3 << 4) #define CLKCFG_MEM_MASK (7 << 4) +#define TR1 0x11006 +#define TSFS 0x11020 +#define TSFS_SLOPE_MASK 0x0000ff00 +#define TSFS_SLOPE_SHIFT 8 +#define TSFS_INTR_MASK 0x000000ff + #define CRSTANDVID 0x11100 #define PXVFREQ_BASE 0x11110 /* P[0-15]VIDFREQ (0x1114c) (Ironlake) */ #define PXVFREQ_PX_MASK 0x7f000000 @@ -964,6 +1073,41 @@ #define MEMSTAT_SRC_CTL_STDBY 3 #define RCPREVBSYTUPAVG 0x113b8 #define RCPREVBSYTDNAVG 0x113bc +#define SDEW 0x1124c +#define CSIEW0 0x11250 +#define CSIEW1 0x11254 +#define CSIEW2 0x11258 +#define PEW 0x1125c +#define DEW 0x11270 +#define MCHAFE 0x112c0 +#define CSIEC 0x112e0 +#define DMIEC 0x112e4 +#define DDREC 0x112e8 +#define PEG0EC 0x112ec +#define PEG1EC 0x112f0 +#define GFXEC 0x112f4 +#define RPPREVBSYTUPAVG 0x113b8 +#define RPPREVBSYTDNAVG 0x113bc +#define ECR 0x11600 +#define ECR_GPFE (1<<31) +#define ECR_IMONE (1<<30) +#define ECR_CAP_MASK 0x0000001f /* Event range, 0-31 */ +#define OGW0 0x11608 +#define OGW1 0x1160c +#define EG0 0x11610 +#define EG1 0x11614 +#define EG2 0x11618 +#define EG3 0x1161c +#define EG4 0x11620 +#define EG5 0x11624 +#define EG6 0x11628 +#define EG7 0x1162c +#define PXW 0x11664 +#define PXWL 0x11680 +#define LCFUSE02 0x116c0 +#define LCFUSE_HIV_MASK 0x000000ff +#define CSIPLL0 0x12c10 +#define DDRMPLL1 0X12c20 #define PEG_BAND_GAP_DATA 0x14d68 /* @@ -1054,8 +1198,6 @@ #define CRT_HOTPLUG_DETECT_DELAY_2G (1 << 4) #define CRT_HOTPLUG_DETECT_VOLTAGE_325MV (0 << 2) #define CRT_HOTPLUG_DETECT_VOLTAGE_475MV (1 << 2) -#define CRT_HOTPLUG_MASK (0x3fc) /* Bits 9-2 */ -#define CRT_FORCE_HOTPLUG_MASK 0xfffffe1f #define PORT_HOTPLUG_STAT 0x61114 #define HDMIB_HOTPLUG_INT_STATUS (1 << 29) @@ -2355,6 +2497,8 @@ #define GT_PIPE_NOTIFY (1 << 4) #define GT_SYNC_STATUS (1 << 2) #define GT_USER_INTERRUPT (1 << 0) +#define GT_BSD_USER_INTERRUPT (1 << 5) + #define GTISR 0x44010 #define GTIMR 0x44014 @@ -2690,6 +2834,9 @@ #define SDVO_ENCODING (0) #define TMDS_ENCODING (2 << 10) #define NULL_PACKET_VSYNC_ENABLE (1 << 9) +/* CPT */ +#define HDMI_MODE_SELECT (1 << 9) +#define DVI_MODE_SELECT (0) #define SDVOB_BORDER_ENABLE (1 << 7) #define AUDIO_ENABLE (1 << 6) #define VSYNC_ACTIVE_HIGH (1 << 4) @@ -2722,6 +2869,7 @@ #define PCH_PP_STATUS 0xc7200 #define PCH_PP_CONTROL 0xc7204 +#define PANEL_UNLOCK_REGS (0xabcd << 16) #define EDP_FORCE_VDD (1 << 3) #define EDP_BLC_ENABLE (1 << 2) #define PANEL_POWER_RESET (1 << 1) |