1 files changed, 0 insertions, 42 deletions
diff --git a/Documentation/devicetree/bindings/spi/spi-sirf.txt b/Documentation/devicetree/bindings/spi/spi-sirf.txt
deleted file mode 100644
index ddd78ff68fae..000000000000
--- a/Documentation/devicetree/bindings/spi/spi-sirf.txt
+++ /dev/null
@@ -1,42 +0,0 @@
-* CSR SiRFprimaII Serial Peripheral Interface
-
-Required properties:
-- compatible : Should be "sirf,prima2-spi", "sirf,prima2-usp"
-               or "sirf,atlas7-usp"
-- reg : Offset and length of the register set for the device
-- interrupts : Should contain SPI interrupt
-- resets: phandle to the reset controller asserting this device in
-          reset
-  See ../reset/reset.txt for details.
-- dmas : Must contain an entry for each entry in clock-names.
-  See ../dma/dma.txt for details.
-- dma-names : Must include the following entries:
-  - rx
-  - tx
-- clocks : Must contain an entry for each entry in clock-names.
-  See ../clocks/clock-bindings.txt for details.
-
-- #address-cells: Number of cells required to define a chip select
-                  address on the SPI bus. Should be set to 1.
-- #size-cells:    Should be zero.
-
-Optional properties:
-- spi-max-frequency: Specifies maximum SPI clock frequency,
-                     Units - Hz. Definition as per
-                     Documentation/devicetree/bindings/spi/spi-bus.txt
-- cs-gpios:     should specify GPIOs used for chipselects.
-
-Example:
-
-spi0: spi@b00d0000 {
-	compatible = "sirf,prima2-spi";
-	reg = <0xb00d0000 0x10000>;
-	interrupts = <15>;
-	dmas = <&dmac1 9>,
-		<&dmac1 4>;
-	dma-names = "rx", "tx";
-	#address-cells = <1>;
-	#size-cells = <0>;
-	clocks = <&clks 19>;
-	resets = <&rstc 26>;
-};