1 files changed, 78 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/eeprom/at24.txt b/Documentation/devicetree/bindings/eeprom/at24.txt
new file mode 100644
index 000000000000..1812c848e369
--- /dev/null
+++ b/Documentation/devicetree/bindings/eeprom/at24.txt
@@ -0,0 +1,78 @@
+EEPROMs (I2C)
+
+Required properties:
+
+  - compatible: Must be a "<manufacturer>,<model>" pair. The following <model>
+                values are supported (assuming "atmel" as manufacturer):
+
+                "atmel,24c00",
+                "atmel,24c01",
+                "atmel,24cs01",
+                "atmel,24c02",
+                "atmel,24cs02",
+                "atmel,24mac402",
+                "atmel,24mac602",
+                "atmel,spd",
+                "atmel,24c04",
+                "atmel,24cs04",
+                "atmel,24c08",
+                "atmel,24cs08",
+                "atmel,24c16",
+                "atmel,24cs16",
+                "atmel,24c32",
+                "atmel,24cs32",
+                "atmel,24c64",
+                "atmel,24cs64",
+                "atmel,24c128",
+                "atmel,24c256",
+                "atmel,24c512",
+                "atmel,24c1024",
+
+                If <manufacturer> is not "atmel", then a fallback must be used
+                with the same <model> and "atmel" as manufacturer.
+
+                Example:
+                        compatible = "microchip,24c128", "atmel,24c128";
+
+                Supported manufacturers are:
+
+                "catalyst",
+                "microchip",
+                "ramtron",
+                "renesas",
+                "nxp",
+                "st",
+
+                Some vendors use different model names for chips which are just
+                variants of the above. Known such exceptions are listed below:
+
+                "renesas,r1ex24002" - the fallback is "atmel,24c02"
+
+  - reg: The I2C address of the EEPROM.
+
+Optional properties:
+
+  - pagesize: The length of the pagesize for writing. Please consult the
+              manual of your device, that value varies a lot. A wrong value
+              may result in data loss! If not specified, a safety value of
+              '1' is used which will be very slow.
+
+  - read-only: This parameterless property disables writes to the eeprom.
+
+  - size: Total eeprom size in bytes.
+
+  - no-read-rollover: This parameterless property indicates that the
+                      multi-address eeprom does not automatically roll over
+                      reads to the next slave address. Please consult the
+                      manual of your device.
+
+  - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
+
+Example:
+
+eeprom@52 {
+	compatible = "atmel,24c32";
+	reg = <0x52>;
+	pagesize = <32>;
+	wp-gpios = <&gpio1 3 0>;
+};