diff options
| -rw-r--r-- | drivers/usb/phy/phy-ab8500-usb.c | 26 |
1 files changed, 25 insertions, 1 deletions
diff --git a/drivers/usb/phy/phy-ab8500-usb.c b/drivers/usb/phy/phy-ab8500-usb.c index 4bb4b1d42f32..20c0f082bf9c 100644 --- a/drivers/usb/phy/phy-ab8500-usb.c +++ b/drivers/usb/phy/phy-ab8500-usb.c @@ -108,7 +108,8 @@ enum ab8500_usb_mode { USB_IDLE = 0, USB_PERIPHERAL, USB_HOST, - USB_DEDICATED_CHG + USB_DEDICATED_CHG, + USB_UART }; /* Register USB_LINK_STATUS interrupt */ @@ -393,6 +394,24 @@ static int ab8505_usb_link_status_update(struct ab8500_usb *ab, usb_phy_set_event(&ab->phy, USB_EVENT_CHARGER); break; + /* + * FIXME: For now we rely on the boot firmware to set up the necessary + * PHY/pin configuration for UART mode. + * + * AB8505 does not seem to report any status change for UART cables, + * possibly because it cannot detect them autonomously. + * We may need to measure the ID resistance manually to reliably + * detect UART cables after bootup. + */ + case USB_LINK_SAMSUNG_UART_CBL_PHY_EN_8505: + case USB_LINK_SAMSUNG_UART_CBL_PHY_DISB_8505: + if (ab->mode == USB_IDLE) { + ab->mode = USB_UART; + ab8500_usb_peri_phy_en(ab); + } + + break; + default: break; } @@ -566,6 +585,11 @@ static irqreturn_t ab8500_usb_disconnect_irq(int irq, void *data) ab->vbus_draw = 0; } + if (ab->mode == USB_UART) { + ab8500_usb_peri_phy_dis(ab); + ab->mode = USB_IDLE; + } + if (is_ab8500_2p0(ab->ab8500)) { if (ab->mode == USB_DEDICATED_CHG) { ab8500_usb_wd_linkstatus(ab, |