diff options
| -rw-r--r-- | Documentation/devicetree/bindings/display/panel/ilitek,ili9322.txt | 49 |
1 files changed, 49 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/display/panel/ilitek,ili9322.txt b/Documentation/devicetree/bindings/display/panel/ilitek,ili9322.txt new file mode 100644 index 000000000000..3d5ce6ad6ec7 --- /dev/null +++ b/Documentation/devicetree/bindings/display/panel/ilitek,ili9322.txt @@ -0,0 +1,49 @@ +Ilitek ILI9322 TFT panel driver with SPI control bus + +This is a driver for 320x240 TFT panels, accepting a variety of input +streams that get adapted and scaled to the panel. The panel output has +960 TFT source driver pins and 240 TFT gate driver pins, VCOM, VCOML and +VCOMH outputs. + +Required properties: + - compatible: "dlink,dir-685-panel", "ilitek,ili9322" + (full system-specific compatible is always required to look up configuration) + - reg: address of the panel on the SPI bus + +Optional properties: + - vcc-supply: core voltage supply, see regulator/regulator.txt + - iovcc-supply: voltage supply for the interface input/output signals, + see regulator/regulator.txt + - vci-supply: voltage supply for analog parts, see regulator/regulator.txt + - reset-gpios: a GPIO spec for the reset pin, see gpio/gpio.txt + + The following optional properties only apply to RGB and YUV input modes and + can be omitted for BT.656 input modes: + + - pixelclk-active: see display/panel/display-timing.txt + - de-active: see display/panel/display-timing.txt + - hsync-active: see display/panel/display-timing.txt + - vsync-active: see display/panel/display-timing.txt + +The panel must obey the rules for a SPI slave device as specified in +spi/spi-bus.txt + +The device node can contain one 'port' child node with one child +'endpoint' node, according to the bindings defined in +media/video-interfaces.txt. This node should describe panel's video bus. + +Example: + +panel: display@0 { + compatible = "dlink,dir-685-panel", "ilitek,ili9322"; + reg = <0>; + vcc-supply = <&vdisp>; + iovcc-supply = <&vdisp>; + vci-supply = <&vdisp>; + + port { + panel_in: endpoint { + remote-endpoint = <&display_out>; + }; + }; +}; |