Merge tag 'mac80211-next-for-davem-2015-08-14' of git://git.kernel.org/pub/scm/linux/kernel/git/jberg/mac80211-next

Johannes Berg says:

====================
Another pull request for the next cycle, this time with quite
a bit of content:
 * mesh fixes/improvements from Alexis, Bob, Chun-Yeow and Jesse
 * TDLS higher bandwidth support (Arik)
 * OCB fixes from Bertold Van den Bergh
 * suspend/resume fixes from Eliad
 * dynamic SMPS support for minstrel-HT (Krishna Chaitanya)
 * VHT bitrate mask support (Lorenzo Bianconi)
 * better regulatory support for 5/10 MHz channels (Matthias May)
 * basic support for MU-MIMO to avoid the multi-vif issue (Sara Sharon)
along with a number of other cleanups.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

2 files changed, 37 insertions, 35 deletions

diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index 883fe1e7c5a1..f0889a247643 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -2369,8 +2369,7 @@ struct cfg80211_qos_map {
  *	method returns 0.)
  *
  * @mgmt_frame_register: Notify driver that a management frame type was
- *	registered. Note that this callback may not sleep, and cannot run
- *	concurrently with itself.
+ *	registered. The callback is allowed to sleep.
  *
  * @set_antenna: Set antenna configuration (tx_ant, rx_ant) on the device.
  *	Parameters are bitmaps of allowed antennas to use for TX/RX. Drivers may
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 6b1077c2a63f..e3314e516681 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -973,6 +973,10 @@ ieee80211_tx_info_clear_status(struct ieee80211_tx_info *info)
  * @RX_FLAG_IV_STRIPPED: The IV/ICV are stripped from this frame.
  *	If this flag is set, the stack cannot do any replay detection
  *	hence the driver or hardware will have to do that.
+ * @RX_FLAG_PN_VALIDATED: Currently only valid for CCMP/GCMP frames, this
+ *	flag indicates that the PN was verified for replay protection.
+ *	Note that this flag is also currently only supported when a frame
+ *	is also decrypted (ie. @RX_FLAG_DECRYPTED must be set)
  * @RX_FLAG_FAILED_FCS_CRC: Set this flag if the FCS check failed on
  *	the frame.
  * @RX_FLAG_FAILED_PLCP_CRC: Set this flag if the PCLP check failed on
@@ -997,9 +1001,6 @@ ieee80211_tx_info_clear_status(struct ieee80211_tx_info *info)
  * @RX_FLAG_AMPDU_DETAILS: A-MPDU details are known, in particular the reference
  *	number (@ampdu_reference) must be populated and be a distinct number for
  *	each A-MPDU
- * @RX_FLAG_AMPDU_REPORT_ZEROLEN: driver reports 0-length subframes
- * @RX_FLAG_AMPDU_IS_ZEROLEN: This is a zero-length subframe, for
- *	monitoring purposes only
  * @RX_FLAG_AMPDU_LAST_KNOWN: last subframe is known, should be set on all
  *	subframes of a single A-MPDU
  * @RX_FLAG_AMPDU_IS_LAST: this subframe is the last subframe of the A-MPDU
@@ -1039,8 +1040,8 @@ enum mac80211_rx_flags {
 	RX_FLAG_NO_SIGNAL_VAL		= BIT(12),
 	RX_FLAG_HT_GF			= BIT(13),
 	RX_FLAG_AMPDU_DETAILS		= BIT(14),
-	RX_FLAG_AMPDU_REPORT_ZEROLEN	= BIT(15),
-	RX_FLAG_AMPDU_IS_ZEROLEN	= BIT(16),
+	RX_FLAG_PN_VALIDATED		= BIT(15),
+	/* bit 16 free */
 	RX_FLAG_AMPDU_LAST_KNOWN	= BIT(17),
 	RX_FLAG_AMPDU_IS_LAST		= BIT(18),
 	RX_FLAG_AMPDU_DELIM_CRC_ERROR	= BIT(19),
@@ -1491,8 +1492,10 @@ enum ieee80211_key_flags {
  * 	- Temporal Authenticator Rx MIC Key (64 bits)
  * @icv_len: The ICV length for this key type
  * @iv_len: The IV length for this key type
+ * @drv_priv: pointer for driver use
  */
 struct ieee80211_key_conf {
+	void *drv_priv;
 	atomic64_t tx_pn;
 	u32 cipher;
 	u8 icv_len;
@@ -1675,7 +1678,6 @@ struct ieee80211_sta_rates {
  * @tdls: indicates whether the STA is a TDLS peer
  * @tdls_initiator: indicates the STA is an initiator of the TDLS link. Only
  *	valid if the STA is a TDLS peer in the first place.
- * @mfp: indicates whether the STA uses management frame protection or not.
  * @txq: per-TID data TX queues (if driver uses the TXQ abstraction)
  */
 struct ieee80211_sta {
@@ -1693,7 +1695,6 @@ struct ieee80211_sta {
 	struct ieee80211_sta_rates __rcu *rates;
 	bool tdls;
 	bool tdls_initiator;
-	bool mfp;
 
 	struct ieee80211_txq *txq[IEEE80211_NUM_TIDS];
 
@@ -1888,6 +1889,9 @@ struct ieee80211_txq {
  * @IEEE80211_HW_SINGLE_SCAN_ON_ALL_BANDS: The HW supports scanning on all bands
  *	in one command, mac80211 doesn't have to run separate scans per band.
  *
+ * @IEEE80211_HW_TDLS_WIDER_BW: The device/driver supports wider bandwidth
+ *	than then BSS bandwidth for a TDLS link on the base channel.
+ *
  * @NUM_IEEE80211_HW_FLAGS: number of hardware flags, used for sizing arrays
  */
 enum ieee80211_hw_flags {
@@ -1920,6 +1924,7 @@ enum ieee80211_hw_flags {
 	IEEE80211_HW_CHANCTX_STA_CSA,
 	IEEE80211_HW_SUPPORTS_CLONED_SKBS,
 	IEEE80211_HW_SINGLE_SCAN_ON_ALL_BANDS,
+	IEEE80211_HW_TDLS_WIDER_BW,
 
 	/* keep last, obviously */
 	NUM_IEEE80211_HW_FLAGS
@@ -3696,20 +3701,28 @@ void ieee80211_free_hw(struct ieee80211_hw *hw);
 void ieee80211_restart_hw(struct ieee80211_hw *hw);
 
 /**
- * ieee80211_napi_add - initialize mac80211 NAPI context
- * @hw: the hardware to initialize the NAPI context on
- * @napi: the NAPI context to initialize
- * @napi_dev: dummy NAPI netdevice, here to not waste the space if the
- *	driver doesn't use NAPI
- * @poll: poll function
- * @weight: default weight
+ * ieee80211_rx_napi - receive frame from NAPI context
+ *
+ * Use this function to hand received frames to mac80211. The receive
+ * buffer in @skb must start with an IEEE 802.11 header. In case of a
+ * paged @skb is used, the driver is recommended to put the ieee80211
+ * header of the frame on the linear part of the @skb to avoid memory
+ * allocation and/or memcpy by the stack.
+ *
+ * This function may not be called in IRQ context. Calls to this function
+ * for a single hardware must be synchronized against each other. Calls to
+ * this function, ieee80211_rx_ni() and ieee80211_rx_irqsafe() may not be
+ * mixed for a single hardware. Must not run concurrently with
+ * ieee80211_tx_status() or ieee80211_tx_status_ni().
+ *
+ * This function must be called with BHs disabled.
  *
- * See also netif_napi_add().
+ * @hw: the hardware this frame came in on
+ * @skb: the buffer to receive, owned by mac80211 after this call
+ * @napi: the NAPI context
  */
-void ieee80211_napi_add(struct ieee80211_hw *hw, struct napi_struct *napi,
-			struct net_device *napi_dev,
-			int (*poll)(struct napi_struct *, int),
-			int weight);
+void ieee80211_rx_napi(struct ieee80211_hw *hw, struct sk_buff *skb,
+		       struct napi_struct *napi);
 
 /**
  * ieee80211_rx - receive frame
@@ -3731,7 +3744,10 @@ void ieee80211_napi_add(struct ieee80211_hw *hw, struct napi_struct *napi,
  * @hw: the hardware this frame came in on
  * @skb: the buffer to receive, owned by mac80211 after this call
  */
-void ieee80211_rx(struct ieee80211_hw *hw, struct sk_buff *skb);
+static inline void ieee80211_rx(struct ieee80211_hw *hw, struct sk_buff *skb)
+{
+	ieee80211_rx_napi(hw, skb, NULL);
+}
 
 /**
  * ieee80211_rx_irqsafe - receive frame
@@ -4315,19 +4331,6 @@ void ieee80211_get_tkip_p2k(struct ieee80211_key_conf *keyconf,
 			    struct sk_buff *skb, u8 *p2k);
 
 /**
- * ieee80211_aes_cmac_calculate_k1_k2 - calculate the AES-CMAC sub keys
- *
- * This function computes the two AES-CMAC sub-keys, based on the
- * previously installed master key.
- *
- * @keyconf: the parameter passed with the set key
- * @k1: a buffer to be filled with the 1st sub-key
- * @k2: a buffer to be filled with the 2nd sub-key
- */
-void ieee80211_aes_cmac_calculate_k1_k2(struct ieee80211_key_conf *keyconf,
-					u8 *k1, u8 *k2);
-
-/**
  * ieee80211_get_key_tx_seq - get key TX sequence counter
  *
  * @keyconf: the parameter passed with the set key