ARM: ux500: move final HREFv60 LCD pins to device tree

Put two extra configs into the device tree to handle the default
configuration of the display reset signals on the HREFv60plus,
move this over from the board file to the device tree.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 17 insertions, 0 deletions

diff --git a/arch/arm/boot/dts/ste-hrefv60plus.dtsi b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
index ecd26848f24f..25b4848e9a6a 100644
--- a/arch/arm/boot/dts/ste-hrefv60plus.dtsi
+++ b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
@@ -102,6 +102,23 @@
 					};
 				 };
 			};
+			mcde {
+				lcd_hrefv60_mode: lcd_hrefv60 {
+					/*
+					 * Display Interface 1 uses GPIO 65 for RST (reset).
+					 * Display Interface 2 uses GPIO 66 for RST (reset).
+					 * Drive DISP1 reset high (not reset), driver DISP2 reset low (reset)
+					 */
+					hrefv60_cfg1 {
+						ste,pins ="GPIO65_F1";
+						ste,config = <&gpio_out_hi>;
+					};
+					hrefv60_cfg2 {
+						ste,pins ="GPIO66_G3";
+						ste,config = <&gpio_out_lo>;
+					};
+				};
+			};
 		};
 	};
 };