dt-bindings: net: Add a YAML schemas for the generic MDIO options

The MDIO buses have a number of available device tree properties that can
be used in their device tree node. Add a YAML schemas for those.

Suggested-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Rob Herring <robh@kernel.org>

1 files changed, 1 insertions, 37 deletions

diff --git a/Documentation/devicetree/bindings/net/mdio.txt b/Documentation/devicetree/bindings/net/mdio.txt
index e3e1603f256c..cf8a0105488e 100644
--- a/Documentation/devicetree/bindings/net/mdio.txt
+++ b/Documentation/devicetree/bindings/net/mdio.txt
@@ -1,37 +1 @@
-Common MDIO bus properties.
-
-These are generic properties that can apply to any MDIO bus.
-
-Optional properties:
-- reset-gpios: One GPIO that control the RESET lines of all PHYs on that MDIO
-  bus.
-- reset-delay-us: RESET pulse width in microseconds.
-
-A list of child nodes, one per device on the bus is expected. These
-should follow the generic phy.txt, or a device specific binding document.
-
-The 'reset-delay-us' indicates the RESET signal pulse width in microseconds and
-applies to all PHY devices. It must therefore be appropriately determined based
-on all PHY requirements (maximum value of all per-PHY RESET pulse widths).
-
-Example :
-This example shows these optional properties, plus other properties
-required for the TI Davinci MDIO driver.
-
-	davinci_mdio: ethernet@5c030000 {
-		compatible = "ti,davinci_mdio";
-		reg = <0x5c030000 0x1000>;
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
-		reset-delay-us = <2>;
-
-		ethphy0: ethernet-phy@1 {
-			reg = <1>;
-		};
-
-		ethphy1: ethernet-phy@3 {
-			reg = <3>;
-		};
-	};
+This file has moved to mdio.yaml.