spi: sh-msiof: Avoid writing to registers from spi_master.setup()

The spi_master.setup() callback must not change configuration registers,
as that could corrupt I/O that is in progress for other SPI slaves.

The only exception is the configuration of the native chip select
polarity in SPI master mode, as a wrong chip select polarity will cause
havoc during all future transfers to any other SPI slave.

Hence stop writing to registers in sh_msiof_spi_setup(), unless it is
the first call for a controller using a native chip select, or unless
native chip select polarity has changed (note that you'll loose anyway
if I/O is in progress).  Even then, only do what is strictly necessary,
instead of calling sh_msiof_spi_set_pin_regs().

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@kernel.org>

1 files changed, 24 insertions, 11 deletions

diff --git a/drivers/spi/spi-sh-msiof.c b/drivers/spi/spi-sh-msiof.c
index 81a9144f5442..2704abb11ea4 100644
--- a/drivers/spi/spi-sh-msiof.c
+++ b/drivers/spi/spi-sh-msiof.c
@@ -55,6 +55,8 @@ struct sh_msiof_spi_priv {
 	void *rx_dma_page;
 	dma_addr_t tx_dma_addr;
 	dma_addr_t rx_dma_addr;
+	bool native_cs_inited;
+	bool native_cs_high;
 	bool slave_aborted;
 };
 
@@ -528,8 +530,7 @@ static int sh_msiof_spi_setup(struct spi_device *spi)
 {
 	struct device_node	*np = spi->master->dev.of_node;
 	struct sh_msiof_spi_priv *p = spi_master_get_devdata(spi->master);
-
-	pm_runtime_get_sync(&p->pdev->dev);
+	u32 clr, set, tmp;
 
 	if (!np) {
 		/*
@@ -539,19 +540,31 @@ static int sh_msiof_spi_setup(struct spi_device *spi)
 		spi->cs_gpio = (uintptr_t)spi->controller_data;
 	}
 
-	/* Configure pins before deasserting CS */
-	sh_msiof_spi_set_pin_regs(p, !!(spi->mode & SPI_CPOL),
-				  !!(spi->mode & SPI_CPHA),
-				  !!(spi->mode & SPI_3WIRE),
-				  !!(spi->mode & SPI_LSB_FIRST),
-				  !!(spi->mode & SPI_CS_HIGH));
-
-	if (spi->cs_gpio >= 0)
+	if (spi->cs_gpio >= 0) {
 		gpio_set_value(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
+		return 0;
+	}
 
+	if (spi_controller_is_slave(p->master))
+		return 0;
 
-	pm_runtime_put(&p->pdev->dev);
+	if (p->native_cs_inited &&
+	    (p->native_cs_high == !!(spi->mode & SPI_CS_HIGH)))
+		return 0;
 
+	/* Configure native chip select mode/polarity early */
+	clr = MDR1_SYNCMD_MASK;
+	set = MDR1_TRMD | TMDR1_PCON | MDR1_SYNCMD_SPI;
+	if (spi->mode & SPI_CS_HIGH)
+		clr |= BIT(MDR1_SYNCAC_SHIFT);
+	else
+		set |= BIT(MDR1_SYNCAC_SHIFT);
+	pm_runtime_get_sync(&p->pdev->dev);
+	tmp = sh_msiof_read(p, TMDR1) & ~clr;
+	sh_msiof_write(p, TMDR1, tmp | set);
+	pm_runtime_put(&p->pdev->dev);
+	p->native_cs_high = spi->mode & SPI_CS_HIGH;
+	p->native_cs_inited = true;
 	return 0;
 }