/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright (C) 2008 by Michael Sevakis * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #include #include "config.h" #include "system.h" #include "kernel.h" #include "avic-imx31.h" #include "ccm-imx31.h" #include "i2c-imx31.h" /* Forward interrupt handler declarations */ #if (I2C_MODULE_MASK & USE_I2C1_MODULE) static __attribute__((interrupt("IRQ"))) void I2C1_HANDLER(void); #endif #if (I2C_MODULE_MASK & USE_I2C2_MODULE) static __attribute__((interrupt("IRQ"))) void I2C2_HANDLER(void); #endif #if (I2C_MODULE_MASK & USE_I2C3_MODULE) static __attribute__((interrupt("IRQ"))) void I2C3_HANDLER(void); #endif static struct i2c_module_descriptor { struct i2c_map *base; /* Module base address */ enum IMX31_CG_LIST cg; /* Clock gating index */ enum IMX31_INT_LIST ints; /* Module interrupt number */ int enable; /* Enable count */ void (*handler)(void); /* Module interrupt handler */ struct mutex m; /* Node mutual-exclusion */ struct wakeup w; /* I2C done signal */ unsigned char *addr_data; /* Additional addressing data */ int addr_count; /* Addressing byte count */ unsigned char *data; /* TX/RX buffer (actual data) */ int data_count; /* TX/RX byte count */ unsigned char addr; /* Address + r/w bit */ } i2c_descs[I2C_NUM_I2C] = { #if (I2C_MODULE_MASK & USE_I2C1_MODULE) { .base = (struct i2c_map *)I2C1_BASE_ADDR, .cg = CG_I2C1, .ints = INT_I2C1, .handler = I2C1_HANDLER, }, #endif #if (I2C_MODULE_MASK & USE_I2C2_MODULE) { .base = (struct i2c_map *)I2C2_BASE_ADDR, .cg = CG_I2C2, .ints = INT_I2C2, .handler = I2C2_HANDLER, }, #endif #if (I2C_MODULE_MASK & USE_I2C3_MODULE) { .base = (struct i2c_map *)I2C3_BASE_ADDR, .cg = CG_I2C3, .ints = INT_I2C3, .handler = I2C3_HANDLER, }, #endif }; static void i2c_interrupt(enum i2c_module_number i2c) { struct i2c_module_descriptor *const desc = &i2c_descs[i2c]; struct i2c_map * const base = desc->base; uint16_t i2sr = base->i2sr; base->i2sr = 0; /* Clear IIF */ if (desc->addr_count >= 0) { /* ADDR cycle - either done or more to send */ if ((i2sr & I2C_I2SR_RXAK) != 0) { goto i2c_stop; /* problem */ } if (--desc->addr_count < 0) { /* Switching to data cycle */ if (desc->addr & 0x1) { base->i2cr &= ~I2C_I2CR_MTX; /* Switch to RX mode */ base->i2dr; /* Dummy read */ return; } /* else remaining data is TX - handle below */ goto i2c_transmit; } else { base->i2dr = *desc->addr_data++; /* Send next addressing byte */ return; } } if (base->i2cr & I2C_I2CR_MTX) { /* Transmitting data */ if ((i2sr & I2C_I2SR_RXAK) == 0) { i2c_transmit: if (desc->data_count > 0) { /* More bytes to send, got ACK from previous byte */ base->i2dr = *desc->data++; desc->data_count--; return; } } /* else done or no ACK received */ } else { /* Receiving data */ if (--desc->data_count > 0) { if (desc->data_count == 1) { /* 2nd to Last byte - NACK */ base->i2cr |= I2C_I2CR_TXAK; } *desc->data++ = base->i2dr; /* Read data from I2DR and store */ return; } else { /* Generate STOP signal before reading data */ base->i2cr &= ~(I2C_I2CR_MSTA | I2C_I2CR_IIEN); *desc->data++ = base->i2dr; /* Read data from I2DR and store */ goto i2c_done; } } i2c_stop: /* Generate STOP signal */ base->i2cr &= ~(I2C_I2CR_MSTA | I2C_I2CR_IIEN); i2c_done: /* Signal thread we're done */ wakeup_signal(&desc->w); } #if (I2C_MODULE_MASK & USE_I2C1_MODULE) static __attribute__((interrupt("IRQ"))) void I2C1_HANDLER(void) { i2c_interrupt(I2C1_NUM); } #endif #if (I2C_MODULE_MASK & USE_I2C2_MODULE) static __attribute__((interrupt("IRQ"))) void I2C2_HANDLER(void) { i2c_interrupt(I2C2_NUM); } #endif #if (I2C_MODULE_MASK & USE_I2C3_MODULE) static __attribute__((interrupt("IRQ"))) void I2C3_HANDLER(void) { i2c_interrupt(I2C3_NUM); } #endif static int i2c_transfer(struct i2c_node * const node, struct i2c_module_descriptor *const desc) { struct i2c_map * const base = desc->base; int count = desc->data_count; uint16_t i2cr; /* Make sure bus is idle. */ while (base->i2sr & I2C_I2SR_IBB); /* Set speed */ base->ifdr = node->ifdr; /* Enable module */ base->i2cr = I2C_I2CR_IEN; /* Enable Interrupt, Master */ i2cr = I2C_I2CR_IEN | I2C_I2CR_IIEN | I2C_I2CR_MTX; if ((desc->addr & 0x1) && desc->data_count < 2) { /* Receiving less than two bytes - disable ACK generation */ i2cr |= I2C_I2CR_TXAK; } /* Set config */ base->i2cr = i2cr; /* Generate START */ base->i2cr = i2cr | I2C_I2CR_MSTA; /* Address slave (first byte sent) and begin session. */ base->i2dr = desc->addr; /* Wait for transfer to complete */ if (wakeup_wait(&desc->w, HZ) == OBJ_WAIT_SUCCEEDED) { count -= desc->data_count; } else { /* Generate STOP if timeout */ base->i2cr &= ~(I2C_I2CR_MSTA | I2C_I2CR_IIEN); count = -1; } desc->addr_count = 0; return count; } int i2c_read(struct i2c_node *node, int reg, unsigned char *data, int data_count) { struct i2c_module_descriptor *const desc = &i2c_descs[node->num]; unsigned char ad[1]; mutex_lock(&desc->m); desc->addr = (node->addr & 0xfe) | 0x1; /* Slave address/rd */ if (reg >= 0) { /* Sub-address */ desc->addr_count = 1; desc->addr_data = ad; ad[0] = reg; } /* else raw read from slave */ desc->data = data; desc->data_count = data_count; data_count = i2c_transfer(node, desc); mutex_unlock(&desc->m); return data_count; } int i2c_write(struct i2c_node *node, const unsigned char *data, int data_count) { struct i2c_module_descriptor *const desc = &i2c_descs[node->num]; mutex_lock(&desc->m); desc->addr = node->addr & 0xfe; /* Slave address/wr */ desc->data = (unsigned char *)data; desc->data_count = data_count; data_count = i2c_transfer(node, desc); mutex_unlock(&desc->m); return data_count; } void i2c_init(void) { int i; /* Do one-time inits for each module that will be used - leave * module disabled and unclocked until something wants it */ for (i = 0; i < I2C_NUM_I2C; i++) { struct i2c_module_descriptor *const desc = &i2c_descs[i]; ccm_module_clock_gating(desc->cg, CGM_ON_RUN_WAIT); mutex_init(&desc->m); wakeup_init(&desc->w); desc->base->i2cr = 0; ccm_module_clock_gating(desc->cg, CGM_OFF); } } void i2c_enable_node(struct i2c_node *node, bool enable) { struct i2c_module_descriptor *const desc = &i2c_descs[node->num]; mutex_lock(&desc->m); if (enable) { if (++desc->enable == 1) { /* First enable */ ccm_module_clock_gating(desc->cg, CGM_ON_RUN_WAIT); avic_enable_int(desc->ints, INT_TYPE_IRQ, INT_PRIO_DEFAULT, desc->handler); } } else { if (desc->enable > 0 && --desc->enable == 0) { /* Last enable */ while (desc->base->i2sr & I2C_I2SR_IBB); /* Wait for STOP */ desc->base->i2cr &= ~I2C_I2CR_IEN; avic_disable_int(desc->ints); ccm_module_clock_gating(desc->cg, CGM_OFF); } } mutex_unlock(&desc->m); } void i2c_lock_node(struct i2c_node *node) { struct i2c_module_descriptor *const desc = &i2c_descs[node->num]; mutex_lock(&desc->m); } void i2c_unlock_node(struct i2c_node *node) { struct i2c_module_descriptor *const desc = &i2c_descs[node->num]; mutex_unlock(&desc->m); }