/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright (C) 2002 by Alan Korr * Copyright (C) 2008 by Frank Gevaerts * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #ifndef __SD_H__ #define __SD_H__ #include #include "mv.h" /* for HAVE_MULTIDRIVE or not */ #ifdef HAVE_BOOTLOADER_USB_MODE #define SD_DRIVER_CLOSE #endif #define SD_BLOCK_SIZE 512 /* XXX : support other sizes ? */ struct storage_info; void sd_enable(bool on); void sd_spindown(int seconds); void sd_sleep(void); void sd_sleepnow(void); bool sd_disk_is_active(void); int sd_soft_reset(void); int sd_init(void); void sd_close(void); int sd_read_sectors(IF_MD2(int drive,) unsigned long start, int count, void* buf); int sd_write_sectors(IF_MD2(int drive,) unsigned long start, int count, const void* buf); void sd_spin(void); int sd_spinup_time(void); /* ticks */ #ifdef STORAGE_GET_INFO void sd_get_info(IF_MD2(int drive,) struct storage_info *info); #endif #ifdef HAVE_HOTSWAP bool sd_removable(IF_MV_NONVOID(int drive)); bool sd_present(IF_MV_NONVOID(int drive)); #endif long sd_last_disk_activity(void); #ifdef CONFIG_STORAGE_MULTI int sd_num_drives(int first_drive); #endif /* SD States */ #define SD_IDLE 0 #define SD_READY 1 #define SD_IDENT 2 #define SD_STBY 3 #define SD_TRAN 4 #define SD_DATA 5 #define SD_RCV 6 #define SD_PRG 7 #define SD_DIS 8 /* SD Commands */ #define SD_GO_IDLE_STATE 0 #define SD_ALL_SEND_CID 2 #define SD_SEND_RELATIVE_ADDR 3 #define SD_SET_DSR 4 #define SD_SWITCH_FUNC 6 #define SD_SET_BUS_WIDTH 6 /* acmd6 */ #define SD_SELECT_CARD 7 /* with card's rca */ #define SD_DESELECT_CARD 7 /* with rca = 0 */ #define SD_SEND_IF_COND 8 #define SD_SEND_CSD 9 #define SD_SEND_CID 10 #define SD_STOP_TRANSMISSION 12 #define SD_SEND_STATUS 13 #define SD_SD_STATUS 13 /* acmd13 */ #define SD_GO_INACTIVE_STATE 15 #define SD_SET_BLOCKLEN 16 #define SD_READ_SINGLE_BLOCK 17 #define SD_READ_MULTIPLE_BLOCK 18 #define SD_SEND_NUM_WR_BLOCKS 22 /* acmd22 */ #define SD_SET_WR_BLK_ERASE_COUNT 23 /* acmd23 */ #define SD_WRITE_BLOCK 24 #define SD_WRITE_MULTIPLE_BLOCK 25 #define SD_PROGRAM_CSD 27 #define SD_ERASE_WR_BLK_START 32 #define SD_ERASE_WR_BLK_END 33 #define SD_ERASE 38 #define SD_APP_OP_COND 41 /* acmd41 */ #define SD_LOCK_UNLOCK 42 #define SD_SET_CLR_CARD_DETECT 42 /* acmd42 */ #define SD_SEND_SCR 51 /* acmd51 */ #define SD_APP_CMD 55 /* SD/MMC status in R1, for native mode (SPI bits are different) Type e : error bit s : status bit r : detected and set for the actual command response x : detected and set during command execution. the host must poll the card by sending status command in order to read these bits. Clear condition a : according to the card state b : always related to the previous command. Reception of a valid command will clear it (with a delay of one command) c : clear by read */ #define SD_R1_OUT_OF_RANGE (1 << 31) /* erx, c */ #define SD_R1_ADDRESS_ERROR (1 << 30) /* erx, c */ #define SD_R1_BLOCK_LEN_ERROR (1 << 29) /* erx, c */ #define SD_R1_ERASE_SEQ_ERROR (1 << 28) /* er, c */ #define SD_R1_ERASE_PARAM (1 << 27) /* exx, c */ #define SD_R1_WP_VIOLATION (1 << 26) /* erx, c */ #define SD_R1_CARD_IS_LOCKED (1 << 25) /* sx, a */ #define SD_R1_LOCK_UNLOCK_FAILED (1 << 24) /* erx, c */ #define SD_R1_COM_CRC_ERROR (1 << 23) /* er, b */ #define SD_R1_ILLEGAL_COMMAND (1 << 22) /* er, b */ #define SD_R1_CARD_ECC_FAILED (1 << 21) /* erx, c */ #define SD_R1_CC_ERROR (1 << 20) /* erx, c */ #define SD_R1_ERROR (1 << 19) /* erx, c */ #define SD_R1_UNDERRUN (1 << 18) /* ex, c */ #define SD_R1_OVERRUN (1 << 17) /* ex, c */ #define SD_R1_CSD_OVERWRITE (1 << 16) /* erx, c */ #define SD_R1_WP_ERASE_SKIP (1 << 15) /* erx, c */ #define SD_R1_CARD_ECC_DISABLED (1 << 14) /* sx, a */ #define SD_R1_ERASE_RESET (1 << 13) /* sr, c */ #define SD_R1_STATUS(x) (x & 0xFFFFE000) #define SD_R1_CURRENT_STATE(x) ((x & 0x00001E00) >> 9) /* sx, b (4 bits) */ #define SD_R1_READY_FOR_DATA (1 << 8) /* sx, a */ #define SD_R1_APP_CMD (1 << 5) /* sr, c */ #define SD_R1_AKE_SEQ_ERROR (1 << 3) /* er, c */ /* SD OCR bits */ #define SD_OCR_CARD_CAPACITY_STATUS (1 << 30) /* Card Capacity Status */ /* All R1 Response flags that indicate Card error(vs MCI Controller error) */ #define SD_R1_CARD_ERROR ( SD_R1_OUT_OF_RANGE \ | SD_R1_ADDRESS_ERROR \ | SD_R1_BLOCK_LEN_ERROR \ | SD_R1_ERASE_SEQ_ERROR \ | SD_R1_ERASE_PARAM \ | SD_R1_WP_VIOLATION \ | SD_R1_LOCK_UNLOCK_FAILED \ | SD_R1_COM_CRC_ERROR \ | SD_R1_ILLEGAL_COMMAND \ | SD_R1_CARD_ECC_FAILED \ | SD_R1_CC_ERROR \ | SD_R1_ERROR \ | SD_R1_UNDERRUN \ | SD_R1_CSD_OVERWRITE \ | SD_R1_WP_ERASE_SKIP \ | SD_R1_AKE_SEQ_ERROR) #endif