/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright (C) 2002 by Heikki Hannikainen, Uwe Freese * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #ifndef _POWERMGMT_H_ #define _POWERMGMT_H_ #include #include "config.h" #define POWER_HISTORY_LEN 2*60 /* 2 hours of samples, one per minute */ enum charge_state_type { /* sorted by increasing charging current (do not change!) */ #if CONFIG_CHARGING >= CHARGING_MONITOR CHARGE_STATE_DISABLED = -2, /* Disable charger use (safety measure) */ CHARGE_STATE_ERROR = -1, /* Some error occurred that should not allow turning on the charger again by software without user intervention (ie. replug) */ #endif DISCHARGING = 0, #if CONFIG_CHARGING >= CHARGING_MONITOR TRICKLE, /* For NiCd, battery maintenence phase */ /* For LiIon, low-current precharge phase */ TOPOFF, /* For NiCd, waiting for dead zone */ /* For LiIon, constant voltage phase */ CHARGING, /* For NiCd, main charge phase */ /* For LiIon, constant current phase */ #endif }; /* tells what the charger is doing */ extern enum charge_state_type charge_state; #ifdef CONFIG_CHARGING /* * Flag that the charger has been plugged in/removed: this is set for exactly * one time through the power loop when the charger has been plugged in. */ enum charger_input_state_type { NO_CHARGER = 0, /* No charger is present */ CHARGER_UNPLUGGED, /* Transitional state during CHARGER=>NO_CHARGER */ CHARGER_PLUGGED, /* Transitional state during NO_CHARGER=>CHARGER */ CHARGER /* Charger is present */ }; /* tells the state of the charge input */ extern enum charger_input_state_type charger_input_state; /* Power input status saved on the power thread each loop */ extern unsigned int power_thread_inputs; #endif /* CONFIG_CHARGING */ #if CONFIG_CHARGING == CHARGING_TARGET /* Include target-specific definitions */ #include "powermgmt-target.h" #endif /* Start up power management thread */ void powermgmt_init(void) INIT_ATTR; /* Generic current values that are intentionally meaningless - config header * should define proper numbers.*/ #ifndef CURRENT_BACKLIGHT #define CURRENT_BACKLIGHT 5 /* additional current when backlight always on */ #endif #if defined(HAVE_RECORDING) && !defined(CURRENT_RECORD) #define CURRENT_RECORD 2 /* additional recording current */ #endif /* HAVE_RECORDING && !CURRENT_RECORD*/ #ifndef CURRENT_USB #define CURRENT_USB 2 /* usual current in mA in USB mode */ #endif #if defined(HAVE_REMOTE_LCD) && !defined(CURRENT_REMOTE) #define CURRENT_REMOTE 2 /* additional current when remote connected */ #endif /* CURRENT_REMOTE && !HAVE_REMOTE_LCD */ #if CONFIG_CHARGING #ifndef CURRENT_MAX_CHG #define CURRENT_MAX_CHG 350 /* maximum charging current */ #endif #endif /* CONFIG_CHARGING */ #ifdef CHARGING_DEBUG_FILE #define POWERMGMT_DEBUG_STACK ((0x1000)/sizeof(long)) #else #define POWERMGMT_DEBUG_STACK 0 #endif #ifndef BATT_AVE_SAMPLES /* slw filter constant unless otherwise specified */ #define BATT_AVE_SAMPLES 128 #endif #ifndef POWER_THREAD_STEP_TICKS /* 2HZ sample rate unless otherwise specified */ #define POWER_THREAD_STEP_TICKS (HZ/2) #endif extern unsigned short power_history[POWER_HISTORY_LEN]; extern const unsigned short battery_level_dangerous[BATTERY_TYPES_COUNT]; extern const unsigned short battery_level_shutoff[BATTERY_TYPES_COUNT]; extern const unsigned short percent_to_volt_discharge[BATTERY_TYPES_COUNT][11]; #if CONFIG_CHARGING extern const unsigned short percent_to_volt_charge[11]; #endif /* Returns battery status, filtered for runtime estimation */ int battery_level(void); /* percent */ int battery_time(void); /* minutes */ int battery_voltage(void); /* filtered batt. voltage in millivolts */ /* Implemented by the target, unfiltered */ int _battery_level(void); /* percent */ int _battery_time(void); /* minutes */ int _battery_voltage(void); /* voltage in millivolts */ #if CONFIG_CHARGING >= CHARGING_TARGET void powermgmt_init_target(void); void charging_algorithm_close(void); void charging_algorithm_step(void); #endif #ifdef HAVE_BATTERY_SWITCH unsigned int input_millivolts(void); /* voltage that device is running from */ #endif /* HAVE_BATTERY_SWITCH */ #if defined(HAVE_BATTERY_SWITCH) || defined(HAVE_RESET_BATTERY_FILTER) /* Set the filtered battery voltage (to adjust it before beginning a charge * cycle for instance where old, loaded readings will likely be invalid). * Also readjust when battery switch is opened or closed. */ void reset_battery_filter(int millivolts); #endif /* HAVE_BATTERY_SWITCH || HAVE_RESET_BATTERY_FILTER */ /* read unfiltered battery info */ void battery_read_info(int *voltage, int *level); /* Tells if the battery level is safe for disk writes */ bool battery_level_safe(void); void set_poweroff_timeout(int timeout); void set_battery_capacity(int capacity); /* set local battery capacity value */ int get_battery_capacity(void); /* get local battery capacity value */ void set_battery_type(int type); /* set local battery type */ void set_sleeptimer_duration(int minutes); int get_sleep_timer(void); void set_keypress_restarts_sleep_timer(bool enable); void handle_auto_poweroff(void); void set_car_adapter_mode(bool setting); void reset_poweroff_timer(void); void cancel_shutdown(void); void shutdown_hw(void); void sys_poweroff(void); /* Returns true if the system should force shutdown for some reason - * eg. low battery */ bool query_force_shutdown(void); #ifdef HAVE_ACCESSORY_SUPPLY void accessory_supply_set(bool); #endif #ifdef HAVE_LINEOUT_POWEROFF void lineout_set(bool); #endif #endif /* _POWERMGMT_H_ */