/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright © 2008 Rafaël Carré * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ /* ARM PrimeCell PL180 SD/MMC controller */ /* MCIStatus bits */ #define MCI_CMD_CRC_FAIL (1<<0) #define MCI_DATA_CRC_FAIL (1<<1) #define MCI_CMD_TIMEOUT (1<<2) #define MCI_DATA_TIMEOUT (1<<3) #define MCI_TX_UNDERRUN (1<<4) #define MCI_RX_OVERRUN (1<<5) #define MCI_CMD_RESP_END (1<<6) #define MCI_CMD_SENT (1<<7) #define MCI_DATA_END (1<<8) #define MCI_START_BIT_ERR (1<<9) #define MCI_DATA_BLOCK_END (1<<10) #define MCI_CMD_ACTIVE (1<<11) /* MCIPower bits */ #define MCI_POWER_OFF 0x0 /* 0x1 is reserved */ #define MCI_POWER_UP 0x2 #define MCI_POWER_ON 0x3 /* bits 5:2 are the voltage */ #define MCI_POWER_OPEN_DRAIN (1<<6) #define MCI_POWER_ROD (1<<7) /* MCIClock bits */ /* bits 7:0 are the clock divider */ #define MCI_CLOCK_ENABLE (1<<8) #define MCI_CLOCK_POWERSAVE (1<<9) #define MCI_CLOCK_BYPASS (1<<10) #define MCI_CLOCK_WIDEBUS (1<<11) /* MCICommand bits */ /* bits 5:0 are the command index */ #define MCI_COMMAND_RESPONSE (1<<6) #define MCI_COMMAND_LONG_RESPONSE (1<<7) #define MCI_COMMAND_INTERRUPT (1<<8) #define MCI_COMMAND_PENDING (1<<9) #define MCI_COMMAND_ENABLE (1<<10)