From 9f756f018a6d9f83556f972ce7fcd6870274efae Mon Sep 17 00:00:00 2001 From: John Fastabend Date: Tue, 29 Jun 2010 18:28:36 +0000 Subject: ixgbe: disable tx engine before disabling tx laser Disabling the tx laser while receiving DMA requests can hang the device. After this occurs the device is in a bad state. The GPIO bit never clears when PCI master access is disabled and a reboot is required to get the device in a good state again. Signed-off-by: John Fastabend Acked-by: Peter P Waskiewicz Jr Signed-off-by: Jeff Kirsher Signed-off-by: David S. Miller --- drivers/net/ixgbe/ixgbe_main.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'drivers') diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c index e237748995c1..7ddd60e7d389 100644 --- a/drivers/net/ixgbe/ixgbe_main.c +++ b/drivers/net/ixgbe/ixgbe_main.c @@ -3684,10 +3684,6 @@ void ixgbe_down(struct ixgbe_adapter *adapter) /* signal that we are down to the interrupt handler */ set_bit(__IXGBE_DOWN, &adapter->state); - /* power down the optics */ - if (hw->phy.multispeed_fiber) - hw->mac.ops.disable_tx_laser(hw); - /* disable receive for all VFs and wait one second */ if (adapter->num_vfs) { /* ping all the active vfs to let them know we are going down */ @@ -3742,6 +3738,10 @@ void ixgbe_down(struct ixgbe_adapter *adapter) (IXGBE_READ_REG(hw, IXGBE_DMATXCTL) & ~IXGBE_DMATXCTL_TE)); + /* power down the optics */ + if (hw->phy.multispeed_fiber) + hw->mac.ops.disable_tx_laser(hw); + /* clear n-tuple filters that are cached */ ethtool_ntuple_flush(netdev); -- cgit v1.2.3