From 3856032a0628e6b94badb9131a706dda185e071d Mon Sep 17 00:00:00 2001 From: Mariusz Bialonczyk Date: Wed, 22 May 2019 12:40:53 +0200 Subject: w1: ds2413: when the slave is not responding during read, select it again The protocol is not allowing to obtain a byte of 0xff for PIO_ACCESS_READ call. It is very likely that the slave was not addressed properly and it is just not respoding (leaving the bus in logic high state) during the read of sampled PIO value. We cannot just call w1_reset_resume_command() because the problem will persist, instead try selecting (addressing) the slave again. Signed-off-by: Mariusz Bialonczyk Signed-off-by: Greg Kroah-Hartman --- drivers/w1/slaves/w1_ds2413.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'drivers/w1/slaves/w1_ds2413.c') diff --git a/drivers/w1/slaves/w1_ds2413.c b/drivers/w1/slaves/w1_ds2413.c index d63778c70568..21f08ac8a4e0 100644 --- a/drivers/w1/slaves/w1_ds2413.c +++ b/drivers/w1/slaves/w1_ds2413.c @@ -24,6 +24,7 @@ #define W1_F3A_FUNC_PIO_ACCESS_READ 0xF5 #define W1_F3A_FUNC_PIO_ACCESS_WRITE 0x5A #define W1_F3A_SUCCESS_CONFIRM_BYTE 0xAA +#define W1_F3A_INVALID_PIO_STATE 0xFF static ssize_t state_read(struct file *filp, struct kobject *kobj, struct bin_attribute *bin_attr, char *buf, loff_t off, @@ -45,6 +46,7 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj, mutex_lock(&sl->master->bus_mutex); dev_dbg(&sl->dev, "mutex locked"); +next: if (w1_reset_select_slave(sl)) goto out; @@ -52,10 +54,15 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj, w1_write_8(sl->master, W1_F3A_FUNC_PIO_ACCESS_READ); *buf = w1_read_8(sl->master); - /* check for correct complement */ if ((*buf & 0x0F) == ((~*buf >> 4) & 0x0F)) { + /* complement is correct */ bytes_read = 1; goto out; + } else if (*buf == W1_F3A_INVALID_PIO_STATE) { + /* slave didn't respond, try to select it again */ + dev_warn(&sl->dev, "slave device did not respond to PIO_ACCESS_READ, " \ + "reselecting, retries left: %d\n", retries); + goto next; } if (w1_reset_resume_command(sl->master)) -- cgit v1.2.3