From dcbe14b91a920657ff3a9ba0efb7c5b5562f956a Mon Sep 17 00:00:00 2001 From: Kleber Sacilotto de Souza Date: Wed, 4 May 2011 13:05:11 +0000 Subject: ehea: fix wrongly reported speed and port Currently EHEA reports to ethtool as supporting 10M, 100M, 1G and 10G and connected to FIBRE independent of the hardware configuration. However, when connected to FIBRE the only supported speed is 10G full-duplex, and the other speeds and modes are only supported when connected to twisted pair. Signed-off-by: Kleber Sacilotto de Souza Acked-by: Breno Leitao Signed-off-by: David S. Miller --- drivers/net/ehea/ehea_ethtool.c | 21 +++++++++++++-------- 1 file changed, 13 insertions(+), 8 deletions(-) (limited to 'drivers/net/ehea') diff --git a/drivers/net/ehea/ehea_ethtool.c b/drivers/net/ehea/ehea_ethtool.c index 3e2e734fecb7..f3bbdcef338c 100644 --- a/drivers/net/ehea/ehea_ethtool.c +++ b/drivers/net/ehea/ehea_ethtool.c @@ -55,15 +55,20 @@ static int ehea_get_settings(struct net_device *dev, struct ethtool_cmd *cmd) cmd->duplex = -1; } - cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_1000baseT_Full - | SUPPORTED_100baseT_Full | SUPPORTED_100baseT_Half - | SUPPORTED_10baseT_Full | SUPPORTED_10baseT_Half - | SUPPORTED_Autoneg | SUPPORTED_FIBRE); - - cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_Autoneg - | ADVERTISED_FIBRE); + if (cmd->speed == SPEED_10000) { + cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_FIBRE); + cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_FIBRE); + cmd->port = PORT_FIBRE; + } else { + cmd->supported = (SUPPORTED_1000baseT_Full | SUPPORTED_100baseT_Full + | SUPPORTED_100baseT_Half | SUPPORTED_10baseT_Full + | SUPPORTED_10baseT_Half | SUPPORTED_Autoneg + | SUPPORTED_TP); + cmd->advertising = (ADVERTISED_1000baseT_Full | ADVERTISED_Autoneg + | ADVERTISED_TP); + cmd->port = PORT_TP; + } - cmd->port = PORT_FIBRE; cmd->autoneg = port->autoneg == 1 ? AUTONEG_ENABLE : AUTONEG_DISABLE; return 0; -- cgit v1.2.3