From d68a5c3d2db408a83e69f12b57b8e19c086d1aee Mon Sep 17 00:00:00 2001 From: "grmoore@altera.com" Date: Mon, 23 Jun 2014 14:21:10 -0500 Subject: mtd: denali: use 8 bytes for READID command The Denali NAND driver reads only 5 bytes of ID, but some Hynix and Samsung have size parameters in the 6th byte. As a result, the page and oob size for a Hynix H27UAG8T2B were calculated incorrectly and the driver failed to load. The solution is to read 8 bytes of ID, as expected by the NAND framework. Signed-off-by: Graham Moore Signed-off-by: Brian Norris --- drivers/mtd/nand/denali.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'drivers/mtd/nand') diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c index 9f2012a3e764..0b071a3136a2 100644 --- a/drivers/mtd/nand/denali.c +++ b/drivers/mtd/nand/denali.c @@ -473,7 +473,7 @@ static void detect_partition_feature(struct denali_nand_info *denali) static uint16_t denali_nand_timing_set(struct denali_nand_info *denali) { uint16_t status = PASS; - uint32_t id_bytes[5], addr; + uint32_t id_bytes[8], addr; uint8_t i, maf_id, device_id; dev_dbg(denali->dev, @@ -488,7 +488,7 @@ static uint16_t denali_nand_timing_set(struct denali_nand_info *denali) addr = (uint32_t)MODE_11 | BANK(denali->flash_bank); index_addr(denali, (uint32_t)addr | 0, 0x90); index_addr(denali, (uint32_t)addr | 1, 0); - for (i = 0; i < 5; i++) + for (i = 0; i < 8; i++) index_addr_read_data(denali, addr | 2, &id_bytes[i]); maf_id = id_bytes[0]; device_id = id_bytes[1]; @@ -1276,7 +1276,7 @@ static void denali_cmdfunc(struct mtd_info *mtd, unsigned int cmd, int col, addr = (uint32_t)MODE_11 | BANK(denali->flash_bank); index_addr(denali, (uint32_t)addr | 0, 0x90); index_addr(denali, (uint32_t)addr | 1, 0); - for (i = 0; i < 5; i++) { + for (i = 0; i < 8; i++) { index_addr_read_data(denali, (uint32_t)addr | 2, &id); -- cgit v1.2.3