From 198bb646e8553e8abd8d83492a27b601ab97b75d Mon Sep 17 00:00:00 2001 From: Jacopo Mondi Date: Wed, 16 Jun 2021 14:46:16 +0200 Subject: media: i2c: rdacm20: Re-work ov10635 reset The OV10635 image sensor embedded in the camera module is currently reset after the MAX9271 initialization with two long delays that were most probably not correctly characterized. Re-work the image sensor reset procedure by holding the chip in reset during the MAX9271 configuration, removing the long sleep delays and only wait after the chip exits from reset for 350-500 microseconds interval, which is larger than the minimum (2048 * (1 / XVCLK)) timeout characterized in the chip manual. Signed-off-by: Jacopo Mondi Reviewed-by: Kieran Bingham Reviewed-by: Laurent Pinchart Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab --- drivers/media/i2c/rdacm20.c | 29 +++++++++++++++++------------ 1 file changed, 17 insertions(+), 12 deletions(-) (limited to 'drivers/media') diff --git a/drivers/media/i2c/rdacm20.c b/drivers/media/i2c/rdacm20.c index 0fc5512cd5e7..025a610de893 100644 --- a/drivers/media/i2c/rdacm20.c +++ b/drivers/media/i2c/rdacm20.c @@ -473,6 +473,19 @@ static int rdacm20_initialize(struct rdacm20_device *dev) if (ret) return ret; + /* + * Hold OV10635 in reset during max9271 configuration. The reset signal + * has to be asserted for at least 200 microseconds. + */ + ret = max9271_enable_gpios(&dev->serializer, MAX9271_GPIO1OUT); + if (ret) + return ret; + + ret = max9271_clear_gpios(&dev->serializer, MAX9271_GPIO1OUT); + if (ret) + return ret; + usleep_range(200, 500); + ret = max9271_configure_gmsl_link(&dev->serializer); if (ret) return ret; @@ -487,22 +500,14 @@ static int rdacm20_initialize(struct rdacm20_device *dev) dev->serializer.client->addr = dev->addrs[0]; /* - * Reset the sensor by cycling the OV10635 reset signal connected to the - * MAX9271 GPIO1 and verify communication with the OV10635. + * Release ov10635 from reset and initialize it. The image sensor + * requires at least 2048 XVCLK cycles (85 micro-seconds at 24MHz) + * before being available. Stay safe and wait up to 500 micro-seconds. */ - ret = max9271_enable_gpios(&dev->serializer, MAX9271_GPIO1OUT); - if (ret) - return ret; - - ret = max9271_clear_gpios(&dev->serializer, MAX9271_GPIO1OUT); - if (ret) - return ret; - usleep_range(10000, 15000); - ret = max9271_set_gpios(&dev->serializer, MAX9271_GPIO1OUT); if (ret) return ret; - usleep_range(10000, 15000); + usleep_range(100, 500); again: ret = ov10635_read16(dev, OV10635_PID); -- cgit v1.2.3