From f8f8c0797d73624d6e81dbb9c9e8f85005500ebc Mon Sep 17 00:00:00 2001 From: Magnus Damm Date: Wed, 19 Aug 2009 09:52:02 +0000 Subject: sh: add r8a66597 usb1 gadget to the se7724 board Add USB gadget support for port CN26 on the Solution Engine 7724 board. The r8a66597-udc driver is hooked up as a platform device and some registers are configured to enable the USB in gadget mode. The hardware driving the USB port is the on-chip USB1 block in the sh7724 processor configured as USB gadget controller. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt --- arch/sh/boards/mach-se/7724/setup.c | 33 +++++++++++++++++++++++++++++++++ 1 file changed, 33 insertions(+) (limited to 'arch') diff --git a/arch/sh/boards/mach-se/7724/setup.c b/arch/sh/boards/mach-se/7724/setup.c index c04e134474d8..e6bd09f2e14a 100644 --- a/arch/sh/boards/mach-se/7724/setup.c +++ b/arch/sh/boards/mach-se/7724/setup.c @@ -341,6 +341,35 @@ static struct platform_device sh7724_usb0_host_device = { .resource = sh7724_usb0_host_resources, }; +static struct r8a66597_platdata sh7724_usb1_gadget_data = { + .on_chip = 1, +}; + +static struct resource sh7724_usb1_gadget_resources[] = { + [0] = { + .start = 0xa4d90000, + .end = 0xa4d90123, + .flags = IORESOURCE_MEM, + }, + [1] = { + .start = 66, + .end = 66, + .flags = IORESOURCE_IRQ | IRQF_TRIGGER_LOW, + }, +}; + +static struct platform_device sh7724_usb1_gadget_device = { + .name = "r8a66597_udc", + .id = 1, /* USB1 */ + .dev = { + .dma_mask = NULL, /* not use dma */ + .coherent_dma_mask = 0xffffffff, + .platform_data = &sh7724_usb1_gadget_data, + }, + .num_resources = ARRAY_SIZE(sh7724_usb1_gadget_resources), + .resource = sh7724_usb1_gadget_resources, +}; + static struct platform_device *ms7724se_devices[] __initdata = { &heartbeat_device, &smc91x_eth_device, @@ -351,6 +380,7 @@ static struct platform_device *ms7724se_devices[] __initdata = { &keysc_device, &sh_eth_device, &sh7724_usb0_host_device, + &sh7724_usb1_gadget_device, }; #define EEPROM_OP 0xBA206000 @@ -459,6 +489,9 @@ static int __init devices_setup(void) /* enable USB0 port */ ctrl_outw(0x0600, 0xa40501d4); + /* enable USB1 port */ + ctrl_outw(0x0600, 0xa4050192); + /* enable IRQ 0,1,2 */ gpio_request(GPIO_FN_INTC_IRQ0, NULL); gpio_request(GPIO_FN_INTC_IRQ1, NULL); -- cgit v1.2.3