From 5280514471c2803776701c43c027038decac1103 Mon Sep 17 00:00:00 2001 From: Robert Richter Date: Thu, 9 Jul 2009 16:02:44 +0200 Subject: x86/oprofile: Enable multiplexing only if the model supports it This patch checks if the model supports multiplexing. Only then multiplexing will be enabled. The code is added to the common x86 initialization. Signed-off-by: Robert Richter --- arch/x86/oprofile/nmi_int.c | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) (limited to 'arch/x86/oprofile') diff --git a/arch/x86/oprofile/nmi_int.c b/arch/x86/oprofile/nmi_int.c index dca7240aeb26..f0fb44725d80 100644 --- a/arch/x86/oprofile/nmi_int.c +++ b/arch/x86/oprofile/nmi_int.c @@ -258,6 +258,12 @@ static int nmi_switch_event(void) return 0; } +static inline void mux_init(struct oprofile_operations *ops) +{ + if (has_mux()) + ops->switch_events = nmi_switch_event; +} + #else inline int op_x86_phys_to_virt(int phys) { return phys; } @@ -265,6 +271,7 @@ static inline void nmi_shutdown_mux(void) { } static inline int nmi_setup_mux(void) { return 1; } static inline void nmi_cpu_setup_mux(int cpu, struct op_msrs const * const msrs) { } +static inline void mux_init(struct oprofile_operations *ops) { } #endif @@ -682,9 +689,6 @@ int __init op_nmi_init(struct oprofile_operations *ops) ops->start = nmi_start; ops->stop = nmi_stop; ops->cpu_type = cpu_type; -#ifdef CONFIG_OPROFILE_EVENT_MULTIPLEX - ops->switch_events = nmi_switch_event; -#endif if (model->init) ret = model->init(ops); @@ -694,6 +698,8 @@ int __init op_nmi_init(struct oprofile_operations *ops) if (!model->num_virt_counters) model->num_virt_counters = model->num_counters; + mux_init(ops); + init_sysfs(); using_nmi = 1; printk(KERN_INFO "oprofile: using NMI interrupt.\n"); -- cgit v1.2.3