From 45116806139743cf35baa01a584e5972e5d833f6 Mon Sep 17 00:00:00 2001 From: Kumar Gala Date: Thu, 13 Oct 2011 10:13:09 -0500 Subject: powerpc/85xx: Setup secondary cores PIR with hard SMP id Normally logical and hard cpu ID are the same, however in same cases like on the P3060 they may differ. Where the logical is 0..5, the hard id goes 0,1,4..7. This can causes issues for places we utilize PIR to index into array like in debug exception handlers for finding the exception stack. Move to setting up PIR with hard_smp_processor_id fixes the issue. Signed-off-by: Kumar Gala --- arch/powerpc/platforms/85xx/smp.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) (limited to 'arch/powerpc') diff --git a/arch/powerpc/platforms/85xx/smp.c b/arch/powerpc/platforms/85xx/smp.c index d6e47464a0d4..190d111fc117 100644 --- a/arch/powerpc/platforms/85xx/smp.c +++ b/arch/powerpc/platforms/85xx/smp.c @@ -48,10 +48,11 @@ smp_85xx_kick_cpu(int nr) const u64 *cpu_rel_addr; __iomem u32 *bptr_vaddr; struct device_node *np; - int n = 0; + int n = 0, hw_cpu = get_hard_smp_processor_id(nr); int ioremappable; - WARN_ON (nr < 0 || nr >= NR_CPUS); + WARN_ON(nr < 0 || nr >= NR_CPUS); + WARN_ON(hw_cpu < 0 || hw_cpu >= NR_CPUS); pr_debug("smp_85xx_kick_cpu: kick CPU #%d\n", nr); @@ -79,7 +80,7 @@ smp_85xx_kick_cpu(int nr) local_irq_save(flags); - out_be32(bptr_vaddr + BOOT_ENTRY_PIR, nr); + out_be32(bptr_vaddr + BOOT_ENTRY_PIR, hw_cpu); #ifdef CONFIG_PPC32 out_be32(bptr_vaddr + BOOT_ENTRY_ADDR_LOWER, __pa(__early_start)); @@ -88,7 +89,7 @@ smp_85xx_kick_cpu(int nr) (ulong)(bptr_vaddr + SIZE_BOOT_ENTRY)); /* Wait a bit for the CPU to ack. */ - while ((__secondary_hold_acknowledge != nr) && (++n < 1000)) + while ((__secondary_hold_acknowledge != hw_cpu) && (++n < 1000)) mdelay(1); #else smp_generic_kick_cpu(nr); -- cgit v1.2.3