From a3f194c6fa928fa290e10cd1a8b5cddada4d3438 Mon Sep 17 00:00:00 2001 From: Hugues Fruchet Date: Fri, 5 May 2017 12:31:20 -0300 Subject: [media] dt-bindings: Document STM32 DCMI bindings This adds documentation of device tree bindings for the STM32 DCMI (Digital Camera Memory Interface). Acked-by: Rob Herring Signed-off-by: Hugues Fruchet Signed-off-by: Hans Verkuil Signed-off-by: Mauro Carvalho Chehab --- .../devicetree/bindings/media/st,stm32-dcmi.txt | 45 ++++++++++++++++++++++ 1 file changed, 45 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/st,stm32-dcmi.txt (limited to 'Documentation') diff --git a/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt b/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt new file mode 100644 index 000000000000..249790a93017 --- /dev/null +++ b/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt @@ -0,0 +1,45 @@ +STMicroelectronics STM32 Digital Camera Memory Interface (DCMI) + +Required properties: +- compatible: "st,stm32-dcmi" +- reg: physical base address and length of the registers set for the device +- interrupts: should contain IRQ line for the DCMI +- resets: reference to a reset controller, + see Documentation/devicetree/bindings/reset/st,stm32-rcc.txt +- clocks: list of clock specifiers, corresponding to entries in + the clock-names property +- clock-names: must contain "mclk", which is the DCMI peripherial clock +- pinctrl: the pincontrol settings to configure muxing properly + for pins that connect to DCMI device. + See Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt. +- dmas: phandle to DMA controller node, + see Documentation/devicetree/bindings/dma/stm32-dma.txt +- dma-names: must contain "tx", which is the transmit channel from DCMI to DMA + +DCMI supports a single port node with parallel bus. It should contain one +'port' child node with child 'endpoint' node. Please refer to the bindings +defined in Documentation/devicetree/bindings/media/video-interfaces.txt. + +Example: + + dcmi: dcmi@50050000 { + compatible = "st,stm32-dcmi"; + reg = <0x50050000 0x400>; + interrupts = <78>; + resets = <&rcc STM32F4_AHB2_RESET(DCMI)>; + clocks = <&rcc 0 STM32F4_AHB2_CLOCK(DCMI)>; + clock-names = "mclk"; + pinctrl-names = "default"; + pinctrl-0 = <&dcmi_pins>; + dmas = <&dma2 1 1 0x414 0x3>; + dma-names = "tx"; + port { + dcmi_0: endpoint { + remote-endpoint = <...>; + bus-width = <8>; + hsync-active = <0>; + vsync-active = <0>; + pclk-sample = <1>; + }; + }; + }; -- cgit v1.2.3