From 62aaa288ab0425b058fd337c5135a32e8c1aeace Mon Sep 17 00:00:00 2001 From: Jean Delvare Date: Mon, 12 Jun 2006 21:48:08 +0200 Subject: [PATCH] scx200_acb: Documentation update Documentation update for the scx200_acb driver. Hopefully this will help future users. References: [lm-sensors] Support of i2c-nscacb (April, May 2005) http://lists.lm-sensors.org/pipermail/lm-sensors/2005-April/011756.html http://lists.lm-sensors.org/pipermail/lm-sensors/2005-May/012043.html [lm-sensors] making a geode i2c slave driver (April 2006) http://lists.lm-sensors.org/pipermail/lm-sensors/2006-April/015998.html Kernel bug #6445 http://bugzilla.kernel.org/show_bug.cgi?id=6445 Signed-off-by: Jean Delvare Signed-off-by: Greg Kroah-Hartman --- Documentation/i2c/busses/scx200_acb | 19 ++++++++++++++++++- 1 file changed, 18 insertions(+), 1 deletion(-) (limited to 'Documentation') diff --git a/Documentation/i2c/busses/scx200_acb b/Documentation/i2c/busses/scx200_acb index f50e69981ec6..7c07883d4dfc 100644 --- a/Documentation/i2c/busses/scx200_acb +++ b/Documentation/i2c/busses/scx200_acb @@ -2,14 +2,31 @@ Kernel driver scx200_acb Author: Christer Weinigel +The driver supersedes the older, never merged driver named i2c-nscacb. + Module Parameters ----------------- -* base: int +* base: up to 4 ints Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices + By default the driver uses two base addresses 0x820 and 0x840. + If you want only one base address, specify the second as 0 so as to + override this default. + Description ----------- Enable the use of the ACCESS.bus controller on the Geode SCx200 and SC1100 processors and the CS5535 and CS5536 Geode companion devices. + +Device-specific notes +--------------------- + +The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820. +If the scx200_acb driver is built into the kernel, add the following +parameter to your boot command line: + scx200_acb.base=0x810,0x820 +If the scx200_acb driver is built as a module, add the following line to +the file /etc/modprobe.conf instead: + options scx200_acb base=0x810,0x820 -- cgit v1.2.3