From aa1acb0451bb27add173d9641d0b74c58889e693 Mon Sep 17 00:00:00 2001 From: "hongbo.zhang" Date: Thu, 15 Nov 2012 18:56:42 +0800 Subject: Thermal: Add ST-Ericsson DB8500 thermal driver. This driver is based on the thermal management framework in thermal_sys.c. A thermal zone device is created with the trip points to which cooling devices can be bound, the current cooling device is cpufreq, e.g. CPU frequency is clipped down to cool the CPU, and other cooling devices can be added and bound to the trip points dynamically. The platform specific PRCMU interrupts are used to active thermal update when trip points are reached. Signed-off-by: hongbo.zhang Reviewed-by: Viresh Kumar Reviewed-by: Francesco Lavra Signed-off-by: Zhang Rui --- .../devicetree/bindings/thermal/db8500-thermal.txt | 44 ++++++++++++++++++++++ 1 file changed, 44 insertions(+) create mode 100644 Documentation/devicetree/bindings/thermal/db8500-thermal.txt (limited to 'Documentation/devicetree/bindings/thermal') diff --git a/Documentation/devicetree/bindings/thermal/db8500-thermal.txt b/Documentation/devicetree/bindings/thermal/db8500-thermal.txt new file mode 100644 index 000000000000..2e1c06fad81f --- /dev/null +++ b/Documentation/devicetree/bindings/thermal/db8500-thermal.txt @@ -0,0 +1,44 @@ +* ST-Ericsson DB8500 Thermal + +** Thermal node properties: + +- compatible : "stericsson,db8500-thermal"; +- reg : address range of the thermal sensor registers; +- interrupts : interrupts generated from PRCMU; +- interrupt-names : "IRQ_HOTMON_LOW" and "IRQ_HOTMON_HIGH"; +- num-trips : number of total trip points, this is required, set it 0 if none, + if greater than 0, the following properties must be defined; +- tripN-temp : temperature of trip point N, should be in ascending order; +- tripN-type : type of trip point N, should be one of "active" "passive" "hot" + "critical"; +- tripN-cdev-num : number of the cooling devices which can be bound to trip + point N, this is required if trip point N is defined, set it 0 if none, + otherwise the following cooling device names must be defined; +- tripN-cdev-nameM : name of the No. M cooling device of trip point N; + +Usually the num-trips and tripN-*** are separated in board related dts files. + +Example: +thermal@801573c0 { + compatible = "stericsson,db8500-thermal"; + reg = <0x801573c0 0x40>; + interrupts = <21 0x4>, <22 0x4>; + interrupt-names = "IRQ_HOTMON_LOW", "IRQ_HOTMON_HIGH"; + + num-trips = <3>; + + trip0-temp = <75000>; + trip0-type = "active"; + trip0-cdev-num = <1>; + trip0-cdev-name0 = "thermal-cpufreq-0"; + + trip1-temp = <80000>; + trip1-type = "active"; + trip1-cdev-num = <2>; + trip1-cdev-name0 = "thermal-cpufreq-0"; + trip1-cdev-name1 = "thermal-fan"; + + trip2-temp = <85000>; + trip2-type = "critical"; + trip2-cdev-num = <0>; +} -- cgit v1.2.3