From c196ce05cfdb7b5a8af12a3096fac9e880d59617 Mon Sep 17 00:00:00 2001 From: Anders Larsen Date: Sun, 18 Aug 2013 11:54:40 +0200 Subject: pch_gbe: ethtool cannot change parameters when link is down When attempting to change e.g. the advertising mask when the link is down ecmd->speed is -1 causing mii_ethtool_sset() to bail out. This bug bit when connecting to a gigabit switch through a 4-pin (industrial) cable, since link negotiation would not complete (both endpoints claimed to be gigabit-capable, but this is not possible with only 4 pins). Any attempt to fix this by setting autonegation to not offer 1000Mbps failed as the setting would not be accepted while the link was still down... Set ecmd->speed to SPEED_1000 to satisfy mii_ethtool_sset() (the actual value of ecmd->speed doesn't matter as long as it is valid, since a re-negotation is forced afterwards). Signed-off-by: Anders Larsen Signed-off-by: David S. Miller --- drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe_ethtool.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe_ethtool.c b/drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe_ethtool.c index 1129db0cdf82..f0ceb89af931 100644 --- a/drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe_ethtool.c +++ b/drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe_ethtool.c @@ -118,6 +118,7 @@ static int pch_gbe_set_settings(struct net_device *netdev, * filled by get_settings() on a down link, speed is -1: */ if (speed == UINT_MAX) { speed = SPEED_1000; + ethtool_cmd_speed_set(ecmd, speed); ecmd->duplex = DUPLEX_FULL; } ret = mii_ethtool_sset(&adapter->mii, ecmd); -- cgit v1.2.3