From 955164ebb8f8d337ca5b8540ae1f9d4def7f0ad0 Mon Sep 17 00:00:00 2001 From: Christophe Ricard Date: Sun, 25 May 2014 22:35:39 +0200 Subject: NFC: dts: st21nfcb_i2c: Add DTS Documentation Describe the properties used by the st21nfcb NFC controller driver. Signed-off-by: Samuel Ortiz --- .../devicetree/bindings/net/nfc/st21nfcb.txt | 33 ++++++++++++++++++++++ 1 file changed, 33 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/nfc/st21nfcb.txt diff --git a/Documentation/devicetree/bindings/net/nfc/st21nfcb.txt b/Documentation/devicetree/bindings/net/nfc/st21nfcb.txt new file mode 100644 index 000000000000..3b58ae480344 --- /dev/null +++ b/Documentation/devicetree/bindings/net/nfc/st21nfcb.txt @@ -0,0 +1,33 @@ +* STMicroelectronics SAS. ST21NFCB NFC Controller + +Required properties: +- compatible: Should be "st,st21nfcb_i2c". +- clock-frequency: I²C work frequency. +- reg: address on the bus +- interrupt-parent: phandle for the interrupt gpio controller +- interrupts: GPIO interrupt to which the chip is connected +- reset-gpios: Output GPIO pin used to reset the ST21NFCB + +Optional SoC Specific Properties: +- pinctrl-names: Contains only one value - "default". +- pintctrl-0: Specifies the pin control groups used for this controller. + +Example (for ARM-based BeagleBoard xM with ST21NFCB on I2C2): + +&i2c2 { + + status = "okay"; + + st21nfcb: st21nfcb@8 { + + compatible = "st,st21nfcb_i2c"; + + reg = <0x08>; + clock-frequency = <400000>; + + interrupt-parent = <&gpio5>; + interrupts = <2 IRQ_TYPE_LEVEL_LOW>; + + reset-gpios = <&gpio5 29 GPIO_ACTIVE_HIGH>; + }; +}; -- cgit v1.2.3