| Age | Commit message (Collapse) | Author |
|---|
|
If reading the device descriptor fails during hub_port_init() fails,
then the port is disabled, disconnecting the device. The port is then
reset at the start of the next init attempt but there is no device to
reset.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
Instead of the home-grown d_fnstart(), d_fnend() and d_printf() macros,
use dev_dbg() or remove the message entirely.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
ASL/PZL updates while the WUSB channel is inactive (i.e., the PZL and
ASL are stopped) may not complete. This causes hangs when removing the
whci-hcd module if a device is still connected (removing the device
does an endpoint_disable which results in an ASL update to remove the
qset).
If the WUSB channel is inactive the update can simply be skipped as the
WHC doesn't care about the state of the ASL/PZL.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
The UWB radio manager coordinates the use of the radio between the
PALs that may be using it. PALs request use of the radio with
uwb_radio_start() and the radio manager will start beaconing if its
not already doing so. When the last PAL has called uwb_radio_stop()
beaconing will be stopped.
In the future, the radio manager will have a more sophisticated channel
selection algorithm, probably following the Channel Selection Policy
from the WiMedia Alliance when it is finalized. For now, channel 9
(BG1, TFC1) is selected.
The user may override the channel selected by the radio manager and may
force the radio to stop beaconing.
The WUSB Host Controller PAL makes use of this and there are two new
debug PAL commands that can be used for testing.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
Using a Reset Device IE to reset a WUSB device is too heavyweight as it
causes the devcie to disconnect (which the USB stack does not expect and
cannot handle). Instead, do a SetAddress(0); SetAddress(AuthAddr) for
authenticated devices.
Unauthenticated devices will not be reset and the stack will have to rely
on the device timing out after TrustTimeout and disconnecting.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
Avoid using printk_ratelimit() in many places because:
- many were error messages reporting broken hardware (it's useful to
get all of these).
- the message itself wasn't useful so the message has been removed.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
Error path for wusb_set_dev_addr() was handled incorrectly. Fix it by
considering error only when return value is negative.
Signed-off-by: Anderson Lizardo <anderson.lizardo@indt.org.br>
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
|
Add the WUSB protocol (MMC management and device connection) code.
Signed-off-by: David Vrabel <david.vrabel@csr.com>
|
