| Age | Commit message (Collapse) | Author |
|---|
|
rtc_register_device() is a managed interface but it doesn't use devres
by itself - instead it marks an rtc_device as "registered" and the devres
callback for devm_rtc_allocate_device() takes care of resource release.
This doesn't correspond with the design behind devres where managed
structures should not be aware of being managed. The correct solution
here is to register a separate devres callback for unregistering the
device.
While at it: rename rtc_register_device() to devm_rtc_register_device()
and add it to the list of managed interfaces in devres.rst. This way we
can avoid any potential confusion of driver developers who may expect
there to exist a corresponding unregister function.
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Link: https://lore.kernel.org/r/20201109163409.24301-8-brgl@bgdev.pl
|
|
Fix the following coccicheck warning:
./drivers/rtc/rtc-da9063.c:246:5-18: WARNING: Comparison to bool
Reported-by: Tosk Robot <tencent_os_robot@tencent.com>
Signed-off-by: Kaixu Xia <kaixuxia@tencent.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Link: https://lore.kernel.org/r/1604649637-1014-1-git-send-email-kaixuxia@tencent.com
|
|
platform_get_irq_byname() might return -errno which later would be
cast to an unsigned int and used in request_irq().
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Tested-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com>
Link: https://lore.kernel.org/r/20191004150510.6278-1-krzk@kernel.org
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux
Pull RTC updates from Alexandre Belloni:
"A huge series from me this cycle. I went through many drivers to set
the date and time range supported by the RTC which helps solving HW
limitation when the time comes (as early as next year for some). This
time, I focused on drivers using .set_mms and .set_mmss64, allowing me
to remove those callbacks. About a third of the patches got reviews, I
actually own the RTCs and I tested another third and the remaining one
are unlikely to cause any issues.
Other than that, a single new driver and the usual fixes here and there.
Summary:
Subsystem:
- set_mmss and set_mmss64 rtc_ops removal
- Fix timestamp value for RTC_TIMESTAMP_BEGIN_1900
- Use SPDX identifier for the core
- validate upper bound of tm->tm_year
New driver:
- Aspeed BMC SoC RTC
Drivers:
- abx80x: use rtc_add_group
- ds3232: nvram support
- pcf85063: add alarm, nvram, offset correction and microcrystal
rv8263 support
- x1205: add of_match_table
- Use set_time instead of set_mms/set_mmss64 for: ab3100, coh901331,
digicolor, ds1672, ds2404, ep93xx, imxdi, jz4740, lpc32xx, mc13xxx,
mxc, pcap, stmp3xxx, test, wm831x, xgene.
- Set RTC range for: ab3100, at91sam9, coh901331, da9063, digicolor,
dm355evm, ds1672, ds2404, ep39xx, goldfish, imxdi, jz4740, lpc32xx,
mc13xxx, mv, mxc, omap, pcap, pcf85063, pcf85363, ps3, sh,
stmp3xxx, sun4v, tegra, wm831x, xgene.
- Switch to rtc_time64_to_tm/rtc_tm_to_time64 for the driver that
properly set the RTC range.
- Use dev_get_drvdata instead of multiple indirections"
* tag 'rtc-5.2' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux: (177 commits)
rtc: snvs: Use __maybe_unused instead of #if CONFIG_PM_SLEEP
rtc: imxdi: remove unused variable
rtc: drop set_mms and set_mmss64
rtc: pcap: convert to SPDX identifier
rtc: pcap: use .set_time
rtc: pcap: switch to rtc_time64_to_tm/rtc_tm_to_time64
rtc: pcap: set range
rtc: digicolor: convert to SPDX identifier
rtc: digicolor: use .set_time
rtc: digicolor: set range
rtc: digicolor: fix possible race condition
rtc: jz4740: convert to SPDX identifier
rtc: jz4740: rework invalid time detection
rtc: jz4740: use dev_pm_set_wake_irq() to simplify code
rtc: jz4740: use .set_time
rtc: jz4740: remove useless check
rtc: jz4740: switch to rtc_time64_to_tm/rtc_tm_to_time64
rtc: jz4740: set range
rtc: 88pm860x: prevent use-after-free on device remove
rtc: Use dev_get_drvdata()
...
|
|
Call the 64bit versions of rtc_tm time conversion now that the range is
enforced by the core.
Acked-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
The DA9062 and DA9063 have a year register that can go up to 0x3F.
Acked-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
Covnert the header of the source file to SPDX.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
The DA9063AD doesn't support alarms on any seconds and its granularity is
the minute. Set uie_unsupported in that case.
Reported-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reported-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Acked-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
The RTC core is always calling rtc_valid_tm after the read_time callback.
It is not necessary to call it before returning from the callback.
Acked-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
|
|
driver did
| static void da9063_tm_to_data(struct rtc_time *tm, u8 *data,
| {
| const struct da9063_compatible_rtc_regmap *config = rtc->config;
|
| data[RTC_SEC] &= ~config->rtc_count_sec_mask;
| data[RTC_SEC] |= tm->tm_sec & config->rtc_count_sec_mask;
| ...
| }
| ...
| static int da9063_rtc_set_time(struct device *dev, struct rtc_time *tm)
| {
| ...
| u8 data[RTC_DATA_LEN];
| int ret;
|
| da9063_tm_to_data(tm, data, rtc);
which means that some bits of stack content (in 'data[]') was masked out
and written to the RTC.
Because da9063_tm_to_data() is used only by da9063_rtc_set_time() and
da9063_rtc_set_alarm(), we can write fields directly.
Signed-off-by: Enrico Scholz <enrico.scholz@sigma-chemnitz.de>
Acked-by: Steve Twiss <stwiss.opensource@diasemi.com>
Tested-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
|
|
This fix alters the ordering of the IRQ and device registrations in the RTC
driver probe function. This change will apply to the RTC driver that supports
both DA9063 and DA9062 PMICs.
A problem could occur with the existing RTC driver if:
A system is started from a cold boot using the PMIC RTC IRQ to initiate a
power on operation. For instance, if an RTC alarm is used to start a
platform from power off.
The existing driver IRQ is requested before the device has been properly
registered.
i.e.
ret = devm_request_threaded_irq()
comes before
rtc->rtc_dev = devm_rtc_device_register();
In this case, the interrupt can be called before the device has been
registered and the handler can be called immediately. The IRQ handler
da9063_alarm_event() contains the function call
rtc_update_irq(rtc->rtc_dev, 1, RTC_IRQF | RTC_AF);
which in turn tries to access the unavailable rtc->rtc_dev.
The fix is to reorder the functions inside the RTC probe. The IRQ is
requested after the RTC device resource has been registered so that
get_irq_byname is the last thing to happen.
Signed-off-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
|
|
Fix misleading and inconsistent copyright header wording.
Alter the copyright header text and MODULE_LICENSE macro to ensure the
GPL v2 licence description is correctly represented.
It will remove the incorrectly LGPL worded text. Words such as "Library"
from the line "GNU Library General Public License"; and replace the word
"library" with "program" in several other places.
The copyright should match the GPL v2 description as specified in the GNU
license found here: http://www.gnu.org/licenses/gpl-2.0.html
It should also match this copyright text with the correct MODULE_LICENSE
macro text as found in the kernel: include/linux/module.h
In this case "GNU Public License v2 or later" is linked with "GPL".
Signed-off-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
|
|
These platform drivers have a OF device ID table but the OF module
alias information is not created so module autoloading won't work.
Signed-off-by: Javier Martinez Canillas <javier@osg.samsung.com>
Acked-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
|
|
Add DA9062 RTC support into the existing DA9063 RTC driver component by
using generic access tables for common register and bit mask definitions.
The following change will add generic register and bit mask support to the
DA9063 RTC. The changes are slightly complicated by requiring support for
three register sets: DA9063-AD, DA9063-BB and DA9062-AA.
The following alterations have been made to the DA9063 RTC:
- Addition of a da9063_compatible_rtc_regmap structure to hold all generic
registers and bitmasks for this type of RTC component.
- A re-write of struct da9063 to use pointers for regmap and compatible
registers/masks definitions
- Addition of a of_device_id table for DA9063 and DA9062 defaults
- Refactoring functions to use struct da9063_compatible_rtc accesses to
generic registers/masks instead of using defines from registers.h
- Re-work of da9063_rtc_probe() to use of_match_node() and dev_get_regmap()
to provide initialisation of generic registers and masks and access to
regmap
Signed-off-by: Steve Twiss <stwiss.opensource@diasemi.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
|
|
A platform_driver does not need to set an owner, it will be populated by the
driver core.
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
|
|
Add register definitions for DA9063 AD (0x3) silicon variant ID
the ability to choose the silicon variant at run-time using regmap
configuration. This patch also adds RTC support for the AD silicon
changes.
It adds both BB and AD support as regmap ranges and then makes the
distinction between the two tables at run-time. This allows both AD
and BB silicon variants to be supported at the same time.
Suggested-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Opensource [Steve Twiss] <stwiss.opensource@diasemi.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
|
|
Add the RTC driver for DA9063.
[akpm@linux-foundation.org: coding-style tweaks]
Signed-off-by: Opensource [Steve Twiss] <stwiss.opensource@diasemi.com>
Cc: Alessandro Zummo <a.zummo@towertech.it>
Cc: Lee Jones <lee.jones@linaro.org>
Cc: Mark Brown <broonie@linaro.org>
Cc: Philipp Zabel <p.zabel@pengutronix.de>
Cc: Samuel Ortiz <sameo@linux.intel.com>
Cc: David Dajun Chen <david.chen@diasemi.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
|
