| Age | Commit message (Collapse) | Author |
|---|
|
Status of ADMA channel registers is not saved and restored during system
suspend. During active playback if system enters suspend, this results in
wrong state of channel registers during system resume and playback fails
to resume properly. Fix this by saving following channel registers in
runtime suspend and restore during runtime resume.
* ADMA_CH_LOWER_SRC_ADDR
* ADMA_CH_LOWER_TRG_ADDR
* ADMA_CH_FIFO_CTRL
* ADMA_CH_CONFIG
* ADMA_CH_CTRL
* ADMA_CH_CMD
* ADMA_CH_TC
Runtime PM calls will be inovked during system resume path if a playback
or capture needs to be resumed. Hence above changes work fine for system
suspend case.
Fixes: f46b195799b5 ("dmaengine: tegra-adma: Add support for Tegra210 ADMA")
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
Following kernel panic is seen during DMA driver unload->load sequence
==========================================================================
Unable to handle kernel paging request at virtual address ffffff8001198880
Internal error: Oops: 86000007 [#1] PREEMPT SMP
CPU: 0 PID: 5907 Comm: HwBinder:4123_1 Tainted: G C 4.9.128-tegra-g065839f
Hardware name: galen (DT)
task: ffffffc3590d1a80 task.stack: ffffffc3d0678000
PC is at 0xffffff8001198880
LR is at of_dma_request_slave_channel+0xd8/0x1f8
pc : [<ffffff8001198880>] lr : [<ffffff8008746f30>] pstate: 60400045
sp : ffffffc3d067b710
x29: ffffffc3d067b710 x28: 000000000000002f
x27: ffffff800949e000 x26: ffffff800949e750
x25: ffffff800949e000 x24: ffffffbefe817d84
x23: ffffff8009f77cb0 x22: 0000000000000028
x21: ffffffc3ffda49c8 x20: 0000000000000029
x19: 0000000000000001 x18: ffffffffffffffff
x17: 0000000000000000 x16: ffffff80082b66a0
x15: ffffff8009e78250 x14: 000000000000000a
x13: 0000000000000038 x12: 0101010101010101
x11: 0000000000000030 x10: 0101010101010101
x9 : fffffffffffffffc x8 : 7f7f7f7f7f7f7f7f
x7 : 62ff726b6b64622c x6 : 0000000000008064
x5 : 6400000000000000 x4 : ffffffbefe817c44
x3 : ffffffc3ffda3e08 x2 : ffffff8001198880
x1 : ffffffc3d48323c0 x0 : ffffffc3d067b788
Process HwBinder:4123_1 (pid: 5907, stack limit = 0xffffffc3d0678028)
Call trace:
[<ffffff8001198880>] 0xffffff8001198880
[<ffffff80087459f8>] dma_request_chan+0x50/0x1f0
[<ffffff8008745bc0>] dma_request_slave_channel+0x28/0x40
[<ffffff8001552c44>] tegra_alt_pcm_open+0x114/0x170
[<ffffff8008d65fa4>] soc_pcm_open+0x10c/0x878
[<ffffff8008d18618>] snd_pcm_open_substream+0xc0/0x170
[<ffffff8008d1878c>] snd_pcm_open+0xc4/0x240
[<ffffff8008d189e0>] snd_pcm_playback_open+0x58/0x80
[<ffffff8008cfc6d4>] snd_open+0xb4/0x178
[<ffffff8008250628>] chrdev_open+0xb8/0x1d0
[<ffffff8008246fdc>] do_dentry_open+0x214/0x318
[<ffffff80082485d0>] vfs_open+0x58/0x88
[<ffffff800825bce0>] do_last+0x450/0xde0
[<ffffff800825c718>] path_openat+0xa8/0x368
[<ffffff800825dd84>] do_filp_open+0x8c/0x110
[<ffffff8008248a74>] do_sys_open+0x164/0x220
[<ffffff80082b66dc>] compat_SyS_openat+0x3c/0x50
[<ffffff8008083040>] el0_svc_naked+0x34/0x38
---[ end trace 67e6d544e65b5145 ]---
Kernel panic - not syncing: Fatal exception
==========================================================================
In device probe(), of_dma_controller_register() registers DMA controller.
But when driver is removed, this is not freed. During driver reload this
results in data abort and kernel panic. Add of_dma_controller_free() in
driver remove path to fix the issue.
Fixes: f46b195799b5 ("dmaengine: tegra-adma: Add support for Tegra210 ADMA")
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
During an audio playback session it is observed that, audio goes off after
few seconds of continuous pause and play. No audio is heard even when the
playback is resumed.
The reason for above is, currently ADMA driver does not handle DMA_PAUSE/
DMA_RESUME and relevant callbacks for dma_device are not implemented. This
patch implements device_pause and device_resume callbacks for the device.
During pause TRANSFER_PAUSE bit of dma channel control register is set and
the same is cleared during resume.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
Add Tegra186 specific macro defines and chip_data structure for chip
specific information. New compatibility is added to select relevant
chip details. There is no major change for Tegra194 and hence it can
use the same chip data.
The bits in the BURST_SIZE field of the ADMA CH_CONFIG register are
encoded differently on Tegra186 and Tegra194 compared with Tegra210.
On Tegra210 the bits are encoded as follows ...
1 = WORD_1
2 = WORDS_2
3 = WORDS_4
4 = WORDS_8
5 = WORDS_16
Where as on Tegra186 and Tegra194 the bits are encoded as ...
0 = WORD_1
1 = WORDS_2
2 = WORDS_3
3 = WORDS_4
4 = WORDS_5
...
15 = WORDS_16
Add helper functions for generating the correct burst size.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
This is a preparatory patch to add support for Tegra186 and Tegra194 chips.
Following changes are necessary to make driver code generic.
* chip_data structure is enhanced to have chip specific details and
following are the additions to the structure
* Offset addresses for ADMA global and channel registers
* Offset values for Tx and Rx channel selection
* Maximum supported Tx and Rx channels
* Tx and Rx channel request mask
* ADMA channel register space size
* Make use of above chip_data to generalise the driver code
Support for Tegra186 and Tegra194 will be added in subsequent patches of
the series.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
If the driver is active till late suspend, where runtime PM cannot run,
force suspend is essential in such case to put the device in low power
state. Thus pm_runtime_force_suspend and pm_runtime_force_resume are
used as system sleep callbacks during system wide PM transitions.
Late system sleep callbacks are used to ensure, for instance, that the
sound core has suspended any on-going activity, including stopping the
ADMA if active, before we attempt to suspend the ADMA.
Suggested-by: Jonathan Hunter <jonathanh@nvidia.com>
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
adma driver is using pm_clk_*() interface for managing clock resources.
With this it is observed that clocks remain ON always. This happens on
Tegra devices which use BPMP co-processor to manage clock resources,
where clocks are enabled during prepare phase. This is necessary because
clocks to BPMP are always blocking. When pm_clk_*() interface is used on
such Tegra devices, clock prepare count is not balanced till remove call
happens for the driver and hence clocks are seen ON always. Thus this
patch replaces pm_clk_*() with devm_clk_*() framework.
Suggested-by: Mohan Kumar D <mkumard@nvidia.com>
Reviewed-by: Jonathan Hunter <jonathanh@nvidia.com>
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
One of the more common cases of allocation size calculations is finding
the size of a structure that has a zero-sized array at the end, along
with memory for some number of elements for that array. For example:
struct foo {
int stuff;
void *entry[];
};
instance = devm_kzalloc(dev, sizeof(struct foo) + sizeof(void *) * count, GFP_KERNEL);
Instead of leaving these open-coded and prone to type mistakes, we can
now use the new struct_size() helper:
instance = devm_kzalloc(dev, struct_size(instance, entry, count), GFP_KERNEL);
This code was detected with the help of Coccinelle.
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
|
|
of_irq_get() may return 0 as well as negative error number on failure,
while the driver only checks for the negative values. The driver would then
call request_irq(0, ...) in tegra_adma_alloc_chan_resources() and never get
valid channel interrupt.
Check for 'tdc->irq <= 0' instead and return -ENXIO from the driver's probe
iff of_irq_get() returned 0.
Fixes: f46b195799b5 ("dmaengine: tegra-adma: Add support for Tegra210 ADMA")
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Acked-by: Thierry Reding <treding@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
|
|
Commit 498b5fdd40dd ("PM / clk: Add support for adding a specific clock
from device-tree") add a new helper function for adding a clock from
device-tree to a device. Update the ADMA driver to use this new function
to simplify the driver.
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Acked-by: Laxman Dewangan <ldewangan@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
|
|
Add support for the Tegra210 Audio DMA controller that is used for
transferring data between system memory and the Audio sub-system.
The driver only supports cyclic transfers because this is being solely
used for audio.
This driver is based upon the work by Dara Ramesh <dramesh@nvidia.com>.
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
|
