summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2012-10-26NFC: Avoid falling back to SYMM when sk is NULLSamuel Ortiz
2012-10-26NFC: Separate pn544 hci driver in HW dependant and independant partsEric Lapuyade
2012-10-26NFC: HCI check presence must not fail when driver doesn't support itEric Lapuyade
2012-10-26NFC: Add pn544 presence check for different targetsArron Wang
2012-10-26NFC: Implement HCI DEP send and receive dataArron Wang
2012-10-26NFC: Implement HCI DEP link up and downArron Wang
2012-10-26NFC: Handle pn544 continue activationArron Wang
2012-10-26NFC: Pass hardware specific HCI event to driverArron Wang
2012-10-26NFC: Set local gb and DEP registriesArron Wang
2012-10-25mac80211: complete bss_info tracingJohannes Berg
2012-10-25mac80211: use non-atomic bitmap operation for local variableJohannes Berg
2012-10-25mac80211: remove duplicate check in ieee80211_rx_mgmt_beaconRami Rosen
2012-10-23cfg80211: add tracing for P2P Device start/stopJohannes Berg
2012-10-23mac80211: expose AES-CMAC subkey calculationAssaf Krauss
2012-10-23mac80211: mesh STAs only process mesh beaconsThomas Pedersen
2012-10-23Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linvil...John W. Linville
2012-10-22mac80211: fix WDS channel context testJohannes Berg
2012-10-19brcm80211: remove some truely barftastic codeAlan Cox
2012-10-19brcmfmac: remove 'always false' condition from brcmf_c_mkiovar_bsscfgArend van Spriel
2012-10-19brcmfmac: fix sparse warningsFranky Lin
2012-10-19brcmfmac: Using zero instead of NULLDan Carpenter
2012-10-19ath9k: perform ANI cycle in idle stateRajkumar Manoharan
2012-10-19carl9170: handle traps from firmware loaderChristian Lamparter
2012-10-19mwifiex: Using %*phD instead of print_hex_dump_bytesAndrei Emeltchenko
2012-10-19mwifiex: use sizeof(array) to print_hex_dump_bytesBing Zhao
2012-10-19rt2800: comment tx power settingsStanislaw Gruszka
2012-10-19rt2800: allow to reduce tx power on devices not exporting power limitStanislaw Gruszka
2012-10-19rt2800: pass channel pointer to rt2800_config_txpowerStanislaw Gruszka
2012-10-19rt2800: use eeprom OFDM 6M TX power as criterionStanislaw Gruszka
2012-10-19rt2800: compensate tx power also for non 11b rates on 2GHzStanislaw Gruszka
2012-10-19rt2800: limit TX_PWR_CFG_ values to 0xcStanislaw Gruszka
2012-10-19rt2800: use BBP_R1 for setting tx powerStanislaw Gruszka
2012-10-19ath_hw: Use common REG_WRITE parameter orderSven Eckelmann
2012-10-19rtlwifi: rtl8192ce: rtl8192cu: use %*phC to dump small buffersAndy Shevchenko
2012-10-19orinoco_usb: clean up some signedness issuesDan Carpenter
2012-10-19bcma: do not initialize deactivated PCIe coresHauke Mehrtens
2012-10-19ath/ath9k/ar9003_eeprom.c: Remove semicolon after ifPeter Senna Tschudin
2012-10-19ath9k: Fix BT_OP_SCAN usageSujith Manoharan
2012-10-19ath9k: Use a helper routine for MCI/FTP tuningSujith Manoharan
2012-10-19bcma: add an extra pcie core structHauke Mehrtens
2012-10-19bcma: use fallback sprom if sprom on card was not validHauke Mehrtens
2012-10-19ssb: add attribute to indicate a parallel flash is availableHauke Mehrtens
2012-10-19ssb: move parallel flash config into an own structHauke Mehrtens
2012-10-19bcma: add some more flash chips for serial flashHauke Mehrtens
2012-10-19bcma: extract drv_cc in bcma_core_mips_flash_detect()Hauke Mehrtens
2012-10-19bcma: mark nflash if it is the boot flashHauke Mehrtens
2012-10-19bcma: add and use constants for the flash windowsHauke Mehrtens
2012-10-19bcma: mark pflash as present when availableHauke Mehrtens
2012-10-19bcma: init sprom struct earlierHauke Mehrtens
2012-10-19bcma: just do the necessary things in early register on SoCsHauke Mehrtens
generated by cgit v1.2.3 (git 2.25.1) at 2024-12-13 17:27:27 +0000