summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2012-09-08Bluetooth: Use module_platform_driver() in btwilink.c fileSachin Kamat
2012-08-21Bluetooth: Fix establishing ESCO linksVinicius Costa Gomes
2012-08-21Bluetooth: Use kref for l2cap channel reference countingSyam Sidhardhan
2012-08-21Bluetooth: debug: Correct the PSM printingSyam Sidhardhan
2012-08-21Bluetooth: mgmt: Add device disconnect reasonMikel Astiz
2012-08-21Bluetooth: Fix minor coding style in hci_event.cMikel Astiz
2012-08-21Bluetooth: Add more HCI error codesMikel Astiz
2012-08-21Bluetooth: trivial: Use preferred method for NULL checkAndrei Emeltchenko
2012-08-15Bluetooth: trivial: Shorten variable scopeAndrei Emeltchenko
2012-08-15Bluetooth: Add type information to the hci_connect() debug statementVinicius Costa Gomes
2012-08-15Bluetooth: Simplify a the connection type handlingVinicius Costa Gomes
2012-08-15Bluetooth: Refactor SCO connection into its own functionVinicius Costa Gomes
2012-08-15Bluetooth: Refactor ACL connection into its own functionVinicius Costa Gomes
2012-08-15Bluetooth: Refactor LE connection into its own functionVinicius Costa Gomes
2012-08-15Bluetooth: Rename LE and ACL connection functionsVinicius Costa Gomes
2012-08-15Bluetooth: Remove some functions from being exportedVinicius Costa Gomes
2012-08-13p54: fix powerpc gcc warningsChristian Lamparter
2012-08-13mac80211: fix unnecessary beacon update after peering status changeMarco Porsch
2012-08-10brcmsmac: document firmware dependenciesJeff Mahoney
2012-08-10ath9k: tune rc_stats to display only valid ratesRajkumar Manoharan
2012-08-10ath9k: Trim rate tableSujith Manoharan
2012-08-10ath9k: Remove MIMO-PS specific codeSujith Manoharan
2012-08-10ath9k: Cleanup TX status APISujith Manoharan
2012-08-10ath9k: Bail out properly before calculating rate indexSujith Manoharan
2012-08-10ath9k: Fix RTS/CTS rate selectionSujith Manoharan
2012-08-10ath9k: Do not set IEEE80211_TX_RC_USE_SHORT_PREAMBLESujith Manoharan
2012-08-10ath9k: Unify valid rate calculation routinesSujith Manoharan
2012-08-10ath9k: Remove ath_rc_set_valid_rate_idxSujith Manoharan
2012-08-10ath9k: Change rateset calculationSujith Manoharan
2012-08-10ath9k: Cleanup index retrieval routinesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_htratesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_ratesSujith Manoharan
2012-08-10ath9k: Cleanup RC init APISujith Manoharan
2012-08-10ath9k: Simplify rate table initializationSujith Manoharan
2012-08-10mwifiex: use GFP_ATOMIC under spin lockDan Carpenter
2012-08-10mwifiex: notify cfg80211 about MIC failuresAmitkumar Karwar
2012-08-10mwifiex: fix 'smatch' warning in preparing key_material cmdBing Zhao
2012-08-10ssb: check for flash presentenceRafał Miłecki
2012-08-10b43legacy: fix logic in GPIO initRafał Miłecki
2012-08-10b43: N-PHY: fix 0x2057 radio calib copy/paste mistakeRafał Miłecki
2012-08-10bcma: add (mostly) NAND definesRafał Miłecki
2012-08-10mwifiex: fix powerpc64-linux- compilation warningsBing Zhao
2012-08-10iwlegacy: clean up suspend/resumeJohannes Berg
2012-08-10mwifiex: fix code mis-alignment after the if statementFengguang Wu
2012-08-10ath5k: Put power_level where it belongs and rename itNick Kossifidis
2012-08-10ath5k: Preserve tx power level requested from above on phy_initNick Kossifidis
2012-08-10ath5k: Fix range scaling when setting rate power tableNick Kossifidis
2012-08-10ath5k: Use correct value for min_pwr and cur_pwrNick Kossifidis
2012-08-10bcma: make some functions staticHauke Mehrtens
2012-08-10p54: parse output power tableChristian Lamparter
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-22 22:51:32 +0000