5 files changed, 7 insertions, 7 deletions
diff --git a/drivers/tty/serial/8250/8250_em.c b/drivers/tty/serial/8250/8250_em.c
index db88dee3a399..f8e99995eee9 100644
--- a/drivers/tty/serial/8250/8250_em.c
+++ b/drivers/tty/serial/8250/8250_em.c
@@ -39,7 +39,7 @@ static void serial8250_em_serial_out(struct uart_port *p, int offset, int value)
 		break;
 	case UART_IER: /* IER @ 0x04 */
 		value &= 0x0f; /* only 4 valid bits - not Xscale */
-		/* fall-through */
+		fallthrough;
 	case UART_DLL_EM: /* DLL @ 0x24 (+9) */
 	case UART_DLM_EM: /* DLM @ 0x28 (+9) */
 		writel(value, p->membase + (offset << 2));
diff --git a/drivers/tty/serial/8250/8250_fintek.c b/drivers/tty/serial/8250/8250_fintek.c
index d1d253c4b518..31c9e83ea3cb 100644
--- a/drivers/tty/serial/8250/8250_fintek.c
+++ b/drivers/tty/serial/8250/8250_fintek.c
@@ -255,7 +255,7 @@ static void fintek_8250_set_irq_mode(struct fintek_8250 *pdata, bool is_level)
 	case CHIP_ID_F81866:
 		sio_write_mask_reg(pdata, F81866_FIFO_CTRL, F81866_IRQ_MODE1,
 				   0);
-		/* fall through */
+		fallthrough;
 	case CHIP_ID_F81865:
 		sio_write_mask_reg(pdata, F81866_IRQ_MODE, F81866_IRQ_SHARE,
 				   F81866_IRQ_SHARE);
diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c
index 1a74d511b02a..3eb2d485eaeb 100644
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -631,7 +631,7 @@ pci_timedia_setup(struct serial_private *priv,
 		break;
 	case 3:
 		offset = board->uart_offset;
-		/* FALLTHROUGH */
+		fallthrough;
 	case 4: /* BAR 2 */
 	case 5: /* BAR 3 */
 	case 6: /* BAR 4 */
diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c
index 09475695effd..06028da9bc6a 100644
--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -1872,7 +1872,7 @@ static bool handle_rx_dma(struct uart_8250_port *up, unsigned int iir)
 	switch (iir & 0x3f) {
 	case UART_IIR_RX_TIMEOUT:
 		serial8250_rx_dma_flush(up);
-		/* fall-through */
+		fallthrough;
 	case UART_IIR_RLSI:
 		return true;
 	}
diff --git a/drivers/tty/serial/8250/8250_uniphier.c b/drivers/tty/serial/8250/8250_uniphier.c
index e0b73a5402db..a2978abab0db 100644
--- a/drivers/tty/serial/8250/8250_uniphier.c
+++ b/drivers/tty/serial/8250/8250_uniphier.c
@@ -75,7 +75,7 @@ static unsigned int uniphier_serial_in(struct uart_port *p, int offset)
 		break;
 	case UART_LCR:
 		valshift = 8;
-		/* fall through */
+		fallthrough;
 	case UART_MCR:
 		offset = UNIPHIER_UART_LCR_MCR;
 		break;
@@ -101,7 +101,7 @@ static void uniphier_serial_out(struct uart_port *p, int offset, int value)
 	case UART_SCR:
 		/* No SCR for this hardware.  Use CHAR as a scratch register */
 		valshift = 8;
-		/* fall through */
+		fallthrough;
 	case UART_FCR:
 		offset = UNIPHIER_UART_CHAR_FCR;
 		break;
@@ -109,7 +109,7 @@ static void uniphier_serial_out(struct uart_port *p, int offset, int value)
 		valshift = 8;
 		/* Divisor latch access bit does not exist. */
 		value &= ~UART_LCR_DLAB;
-		/* fall through */
+		fallthrough;
 	case UART_MCR:
 		offset = UNIPHIER_UART_LCR_MCR;
 		break;