diff options
Diffstat (limited to 'drivers/net/tg3.c')
| -rw-r--r-- | drivers/net/tg3.c | 37 |
1 files changed, 24 insertions, 13 deletions
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c index 5514828b7929..16bc05fe531f 100644 --- a/drivers/net/tg3.c +++ b/drivers/net/tg3.c @@ -1062,7 +1062,7 @@ static void tg3_frob_aux_power(struct tg3 *tp) { struct tg3 *tp_peer = tp; - if ((tp->tg3_flags & TG3_FLAG_EEPROM_WRITE_PROT) != 0) + if ((tp->tg3_flags2 & TG3_FLG2_IS_NIC) == 0) return; if ((GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5704) || @@ -1213,8 +1213,8 @@ static int tg3_set_power_state(struct tg3 *tp, pci_power_t state) power_control); udelay(100); /* Delay after power state change */ - /* Switch out of Vaux if it is not a LOM */ - if (!(tp->tg3_flags & TG3_FLAG_EEPROM_WRITE_PROT)) + /* Switch out of Vaux if it is a NIC */ + if (tp->tg3_flags2 & TG3_FLG2_IS_NIC) tw32_wait_f(GRC_LOCAL_CTRL, tp->grc_local_ctrl, 100); return 0; @@ -6397,16 +6397,17 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy) udelay(40); /* tp->grc_local_ctrl is partially set up during tg3_get_invariants(). - * If TG3_FLAG_EEPROM_WRITE_PROT is set, we should read the + * If TG3_FLG2_IS_NIC is zero, we should read the * register to preserve the GPIO settings for LOMs. The GPIOs, * whether used as inputs or outputs, are set by boot code after * reset. */ - if (tp->tg3_flags & TG3_FLAG_EEPROM_WRITE_PROT) { + if (!(tp->tg3_flags2 & TG3_FLG2_IS_NIC)) { u32 gpio_mask; - gpio_mask = GRC_LCLCTRL_GPIO_OE0 | GRC_LCLCTRL_GPIO_OE2 | - GRC_LCLCTRL_GPIO_OUTPUT0 | GRC_LCLCTRL_GPIO_OUTPUT2; + gpio_mask = GRC_LCLCTRL_GPIO_OE0 | GRC_LCLCTRL_GPIO_OE1 | + GRC_LCLCTRL_GPIO_OE2 | GRC_LCLCTRL_GPIO_OUTPUT0 | + GRC_LCLCTRL_GPIO_OUTPUT1 | GRC_LCLCTRL_GPIO_OUTPUT2; if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5752) gpio_mask |= GRC_LCLCTRL_GPIO_OE3 | @@ -6418,8 +6419,9 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy) tp->grc_local_ctrl |= tr32(GRC_LOCAL_CTRL) & gpio_mask; /* GPIO1 must be driven high for eeprom write protect */ - tp->grc_local_ctrl |= (GRC_LCLCTRL_GPIO_OE1 | - GRC_LCLCTRL_GPIO_OUTPUT1); + if (tp->tg3_flags & TG3_FLAG_EEPROM_WRITE_PROT) + tp->grc_local_ctrl |= (GRC_LCLCTRL_GPIO_OE1 | + GRC_LCLCTRL_GPIO_OUTPUT1); } tw32_f(GRC_LOCAL_CTRL, tp->grc_local_ctrl); udelay(100); @@ -9963,8 +9965,10 @@ static void __devinit tg3_get_eeprom_hw_cfg(struct tg3 *tp) tp->tg3_flags |= TG3_FLAG_EEPROM_WRITE_PROT; if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) { - if (!(tr32(PCIE_TRANSACTION_CFG) & PCIE_TRANS_CFG_LOM)) + if (!(tr32(PCIE_TRANSACTION_CFG) & PCIE_TRANS_CFG_LOM)) { tp->tg3_flags &= ~TG3_FLAG_EEPROM_WRITE_PROT; + tp->tg3_flags2 |= TG3_FLG2_IS_NIC; + } return; } @@ -10064,10 +10068,17 @@ static void __devinit tg3_get_eeprom_hw_cfg(struct tg3 *tp) tp->pdev->subsystem_vendor == PCI_VENDOR_ID_DELL) tp->led_ctrl = LED_CTRL_MODE_PHY_2; - if (nic_cfg & NIC_SRAM_DATA_CFG_EEPROM_WP) + if (nic_cfg & NIC_SRAM_DATA_CFG_EEPROM_WP) { tp->tg3_flags |= TG3_FLAG_EEPROM_WRITE_PROT; - else + if ((tp->pdev->subsystem_vendor == + PCI_VENDOR_ID_ARIMA) && + (tp->pdev->subsystem_device == 0x205a || + tp->pdev->subsystem_device == 0x2063)) + tp->tg3_flags &= ~TG3_FLAG_EEPROM_WRITE_PROT; + } else { tp->tg3_flags &= ~TG3_FLAG_EEPROM_WRITE_PROT; + tp->tg3_flags2 |= TG3_FLG2_IS_NIC; + } if (nic_cfg & NIC_SRAM_DATA_CFG_ASF_ENABLE) { tp->tg3_flags |= TG3_FLAG_ENABLE_ASF; @@ -10693,7 +10704,7 @@ static int __devinit tg3_get_invariants(struct tg3 *tp) tp->tg3_flags |= TG3_FLAG_SRAM_USE_CONFIG; /* Get eeprom hw config before calling tg3_set_power_state(). - * In particular, the TG3_FLAG_EEPROM_WRITE_PROT flag must be + * In particular, the TG3_FLG2_IS_NIC flag must be * determined before calling tg3_set_power_state() so that * we know whether or not to switch out of Vaux power. * When the flag is set, it means that GPIO1 is used for eeprom |