diff options
Diffstat (limited to 'drivers/mtd/nand/onenand/Kconfig')
| -rw-r--r-- | drivers/mtd/nand/onenand/Kconfig | 71 |
1 files changed, 71 insertions, 0 deletions
diff --git a/drivers/mtd/nand/onenand/Kconfig b/drivers/mtd/nand/onenand/Kconfig new file mode 100644 index 000000000000..9dc15748947b --- /dev/null +++ b/drivers/mtd/nand/onenand/Kconfig @@ -0,0 +1,71 @@ +menuconfig MTD_ONENAND + tristate "OneNAND Device Support" + depends on MTD + depends on HAS_IOMEM + help + This enables support for accessing all type of OneNAND flash + devices. + +if MTD_ONENAND + +config MTD_ONENAND_VERIFY_WRITE + bool "Verify OneNAND page writes" + help + This adds an extra check when data is written to the flash. The + OneNAND flash device internally checks only bits transitioning + from 1 to 0. There is a rare possibility that even though the + device thinks the write was successful, a bit could have been + flipped accidentally due to device wear or something else. + +config MTD_ONENAND_GENERIC + tristate "OneNAND Flash device via platform device driver" + help + Support for OneNAND flash via platform device driver. + +config MTD_ONENAND_OMAP2 + tristate "OneNAND on OMAP2/OMAP3 support" + depends on ARCH_OMAP2 || ARCH_OMAP3 + depends on OF || COMPILE_TEST + help + Support for a OneNAND flash device connected to an OMAP2/OMAP3 SoC + via the GPMC memory controller. + Enable dmaengine and gpiolib for better performance. + +config MTD_ONENAND_SAMSUNG + tristate "OneNAND on Samsung SOC controller support" + depends on ARCH_S3C64XX || ARCH_S5PV210 || ARCH_EXYNOS4 + help + Support for a OneNAND flash device connected to an Samsung SOC. + S3C64XX uses command mapping method. + S5PC110/S5PC210 use generic OneNAND method. + +config MTD_ONENAND_OTP + bool "OneNAND OTP Support" + help + One Block of the NAND Flash Array memory is reserved as + a One-Time Programmable Block memory area. + Also, 1st Block of NAND Flash Array can be used as OTP. + + The OTP block can be read, programmed and locked using the same + operations as any other NAND Flash Array memory block. + OTP block cannot be erased. + + OTP block is fully-guaranteed to be a valid block. + +config MTD_ONENAND_2X_PROGRAM + bool "OneNAND 2X program support" + help + The 2X Program is an extension of Program Operation. + Since the device is equipped with two DataRAMs, and two-plane NAND + Flash memory array, these two component enables simultaneous program + of 4KiB. Plane1 has only even blocks such as block0, block2, block4 + while Plane2 has only odd blocks such as block1, block3, block5. + So MTD regards it as 4KiB page size and 256KiB block size + + Now the following chips support it. (KFXXX16Q2M) + Demux: KFG2G16Q2M, KFH4G16Q2M, KFW8G16Q2M, + Mux: KFM2G16Q2M, KFN4G16Q2M, + + And more recent chips + +endif # MTD_ONENAND |